Search results

Stoked to have the bike noticed by someone in the UK whom advised his brother and a few friends originally built the bike in the 90’s for Irish road racing and he was kind enough to send some old pics so stoked. Gave me a history and told me who did the gram mods etc was so good. Sent from...

Tank and seat back finally [emoji1319] Sent from my iPhone using DO THE TON

From these guys mate lockeed replicas https://www.britishbikebits.com/brake-parts Sent from my iPhone using DO THE TON

Bit more on exhaust carbs throttle brake measured spacers for new off set sprockets. The list goes on. Sent from my iPhone using DO THE TON

Turns out I changed my mind on colour now we are doing two tone eeep Sent from my iPhone using DO THE TON

Tree bearings from the fzr and Honda mix match was a bit of a nightmare but she finally works. Sent from my iPhone using DO THE TON

Slowly plodding along bearings ordered swing arm in more bits bolted on Sent from my iPhone using DO THE TON

Finally some progress spokes ordered and re assembly begins. Sent from my iPhone using DO THE TON

And she’s finally back together and on her way home. Sent from my iPhone using DO THE TON

Sent from my iPhone using DO THE TON

Base coat done hopefully she will be rolling in a few weeks Sent from my iPhone using DO THE TON

I’ll double check the head mate cheers. Unsure about the pistons my good mate is an engine builder and he is looking after the freshen up I’m just the nuisance in the road. The gt is running so good, brakes better then my 86 gsxr and every time I throw a leg over I can’t stop smiling. Sent...

Some progress. Seal kit and head gasket turned up so toke to put her back together. Here are some pics of the valve work and squish pistons. Sent from my iPhone using DO THE TON

Plating back looking ok so far. Sent from my iPhone using DO THE TON

Sent from my iPhone using DO THE TON

Ceramic coated gear came back a treat. Miscellaneous bits ready to go to platters before pics. I’ll be sorting out the fiberglass on fairing tomorrow then off to paint with the tank seat and forks. Sent from my iPhone using DO THE TON

Frame back from blaster and now off to powder coat Sent from my iPhone using DO THE TON

Hubs came up a treat and pads look brand new after a soda blast. Also ceramic coat looks good on the pipes too. Pic to follow. Sent from my iPhone using DO THE TON

Few bits showed up Offset sproc Sent from my iPhone using DO THE TON

Last bit fab work complete and bike is now stripped. Few parts on order: Sprockets Swingarm dust seals Kill switch Tacho plug Chain and I’m sure I have forgotten a few more. Tank and seat at paint with fork legs. Exhaust on its way to be ceramic coated Steel bits off to the platers...