Search results

Not to far, PM me a price your looking for.

Hey I need to know what seal this is I damaged it taking off my front sprocket and can't locate a replacement. It is directly behind the front sprocket. Thanks a ton. Also if anyone knows where I can find one that would be great.

Side covers?

Do you have the original seat pan?

Re: My CM400T Cafe Build - Now a CMB400 Frankenfe Cool, what filters did you go with? And did you have to do anything else to the carbs to get it to run well. I've always heard POD filters and CM400's don't mix well.

Re: My CM400T Cafe Build - Now a CMB400 Frankenfe Any update to this?

I love how you did the LED's. How did you go about getting that done?

I was looking at putting the acewell on my CM400, to clean it up a good bit. Couple of questions though. First the Speedo cable here...

I know they are cheap but if anyone is selling some cheaper let me know. Prefer Black. Thanks, Brad

PM me how much for the chain guard.

I'll take the headlight ears. Just shoot me how you want to be payed.

Phewww got them working. I'll post an update of how it ha;ppened soon.

Man this bike is going to drive me crazy. I'm going to go ahead and get some LED signals for the front. But after I took that picture I went out put the headlight on and now that doesn't work either!!!

Alright so heres where I'm at. I'm almost 100% sure the switch works. I added an LED rear Tailight/Turn Signal combo. Now the signals won't flash or turn off for that matter but when I move the switch you can just barely see a change in the light. Such as if I select right turn signal the...

Thanks, right now I don't have anything so I'll get one and see if that takes care of the problem. Also is there any stores that sell these flash relays or internet only?

Also should I get this to replace it? Since I have LED rear now? http://cgi.ebay.com/ebaymotors/LED-Turn-Signal-Flasher-Unit-12-Volt-2-Prong-Hot-Street-Rat-Rod-Motorcycle-?cmd=ViewItem&item=130573260547#ht_1090wt_956

Thanks I was looking all over for that thing today. So would that explain why the turn signals aren't working? Or should they still work without it.

Also I added a all in one tail light/ turn signals for the rear light. Do I need to do an aftermarket flash unit for that?

So heres where I'm at right now, or how I bought it: This is the headlight and turn signal set up. And here are about the only two wires I couldn't account for. Maybe this has something to do with it? The wiring diagram in the manual is way to blurry to read. And yes the...

Ok so I'm having some issues with my CM400e. Mainly the turn signals not working. I pulled out the headlight today and everything looked fine but then again I'm not sure what I'm looking for. Is there a way to bypass the stock system or any advice on where to start? Bulbs looked fine...