Search results

What the hell happened to the threads on those plugs? :o

http://www.ebay.com/itm/HONDA-CB550-FOUR-CB-550-CARBURETOR-MAIN-JET-LEAF-SPRING-MANE-JET-FLOAT-BOWL-/160671033697

The guys over at the SOHC Forum say they read somewhere that this will only be sold over seas. They're not brining it to the states. They don't think the market is there for a "cafe looking" bike in the US. If that is the case.......THAT SUCK! That thing is pretty f@ckin' sweet!

+1 on the impact driver +1 on the hammer and chisel I add a little heat to the mix as well. Take my torch and heat the area around the screw. Seemed to work a little easier.

I have a 77 CB550 and noticed the same thing with my rear bearings. The spacer will move though. I ended up putting my drift against the lip of the spacer (at the top where the drift enters the hub) and gave it a few cracks with the hammer. The spacer slit over enough to get a grip in the...

Re: TATTOO's... Lets see what ya got!!.. Hey...I was a Sigma Nu at the University of Cincinnati......never got a tat though!

Not mine, and I don't know anythinig about these things. I simply ran across the ad and wanted to let you guys know in case you are in the market for a new project. 1st - 77'Hondamatic $1000.00 2nd - 82' Yamaha seca 550 $700.00 3rd - 79' Honda cb650 needs carb work $500.00 4th - 71' Honda...

Here's a bike built by a guy on the SOHC Forum site......He tried to replicate a RC172. I think its a CB 400. Pretty close to what your lookin at. Here's the thread...... http://forums.sohc4.net/index.php?topic=20396.0 Thread with final picture (gotta scroll down a bit) ...

Hey....I'm not sure where you are located or what price you have in mind, but I found this on Craigslist.... http://dayton.craigslist.org/mcy/762981492.html I don't know much about these things so I have not idea if the price is too high or not........too high for me though... :-[ Good luck...

Well hell....I have a K model; although I remember the emblems on the sidecovers said supersport? It has the 4 exhausts so I'm pretty sure it's the K. Title says K, but I never compaired the title to the frame. :o I only paid $50.00 for the thing anyway, so I'm not too concerned. I...

Hey guys. I'm Chris.....new to this board. What did you do to get such an upward "lift" on the tail of the bike. I have a 77 550 that I'm going to start working on later this month and I seem to recall (it's in storage or I would look) the frame and the tank/seat lines are fairly flat. How...