Search results

OK guys I need a little help with the functioning of my kill switch. I'm not too good with electricals so apologies n advance. The bike is a 69 or 70 CB350 twin. The wiring diagram shows a live (black) wire running to the kill switch after which it turns to black/white, splits and runs to each...

Hi folks, I have a CB350 that I have built a wiring loom for from scratch. Everything works just fine BUT I have changed the starter motor button to this: The red button is backlit by a light. I want the light to light up when the key is switched on but to then switch off when the engine...

I'm rebuilding a 1970 CB350 and I'm completely rewiring everything on it. In addition I have one of Rick's combined regulator/rectifier units to replace the original separate regulator and rectifier. The original wiring coming out of the stator has 2 yellow wires and one red wire (plus a...

OK so I'm putting my CB350 crank back into the upper case and there seems to be a problem. I have pulled apart my engine, rebored the barrels and pistons, recut valve seats and refaced valves. I split the cases mainly to satisfy my curiosity about what goes on down there in the cases but also...

This is a quick post to introduce myself. I've been following the site for a few months now and have decided I should become a little more involved in the social side of things here. I've always had a bike of some sort since I was a teen and I'll be turning 50 later this year. For the last 25...