Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
I know I'm supposed to synchronize them but it says to do it with a warm engine...about ten minutes of driving...that's impossible at this time. The manual says there are two screws used for calibrating the idle. One has a black little wheel that you can grip and spin and the others are...
Ok that worked. But now I can't seem to get he idle right....I'll hold the choke in the close position...fires right up but a few seconds later the idle is irratic and it will shoot to 3-3.5k...so I'll open the choke a little and it will drop but sometimes will stall.
Ok so this is where I am now. I started the bike yesterday and noticed only one side would fire right away but the right side would not. Now my coil pack and wires look like crap cause when we put starter fluid in the spark plug hole it fired then died. Also I noticed fuel at the tip of the hose...
Yes, the wires are corroded a their protective covering basically falls off on its own. Also I tried to see if there was any spark when I would try to start the engine and nothing. Any ideas?
as title says, i took my real wheel apart because of the "play" i was getting and i see that the damper rubber is worn out and cracked in several places. I need to replace these but i have no idea where to buy them from..i tried ebay and only one match came up..but it looked just as bad as mine.
today i finally finished with what i was doing to it and managed to get power to it....once the ignition was turned to "on" my lights came on, even the ones in the gauge cluster...then i hear some noise coming from where the electrical stuff is at...and then all power is shut down. i check the...
Sorry I posted this somewhere else already but I figured this is the best place...I found the site that sells them, what dimensions did you end up putting on your bike? Thanks man
We're your UNi Air filters from eBay? This is exactly what I'm doing...I even have the same bars...been trying to salvage the tank for a long ass time now.
what size of fuel line did this thing originally come with? i've searched and looked at the manual and i can't find the answer. :( also, the size of the fuel petcock. or does the size even matter as long as it matches the carb/petcock size?
thanks.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.