Search results

I was digging through a bunch of old build parts and found a pair of complete Mikuni's. I can't remember what they're from, but they are complete and in great condition. Figured someone on here might know, and could use them. I initially thought they were bs38's. But I don't believe so...

I have 2 pairs of cb350 twin (K22a) carbs. 2 brand new rebuild kits. 1 set has been through a hot tank and ready to be put back together. Diaphrams are in perfect condition. Looking to get $100 + shipping for everything.

Need a front disc brake caliper from a 73 350G. Let me know what ya got.

Kz650 Parts Side covers - $50 Swing arm (non disc) - $40 18" Spoked wheel with 5k orig. miles hub and decent tire -$100 Front fender $20 + the ride Cb350 twin parts: '73 front fender -$20 + the ride Keihin 722a (2 pair) - They have all been disassembled and ran through a sonic cleaner. -$100...

Let me know what ya got. Need these for my cb350g. stockers are trashed :(

I've had this thing soaking in penetrating oil for about 6 hours now, and have literally tried everything. It won't even budge. Not sure what else to do, other than finding maybe a small puller set like a steering wheel puller? Any suggestions?

Literally, every wire on the front end of my project 350 was twisted and wrapped with electrical tape. I've rewired the rear of the bike, so i'm tackling the front today and have a few questions because some of the wires on my diagram are hard to make out. I had to pull apart the switches and...

When I was pulling the motor out of my cb350g, this sleeve fell out from somewhere. There's only 1, and I can't find where it goes. I'm putting the motor back in tomorrow, and while this doesn't seem like it came from any of the mounts, I just want to make sure. Thanks guys.

I was going to use them on a hardtail project, but never did. They are still brand new, never mounted, just a little dirty from sitting around the shop. Paid $40. Looking to get $25 shipped out of them. Paypal only.

Pulled my motor on my cafe project. Not sure if I should tear into it to rebuild. Bike has 23k miles. I just pulled off the top cover to check out the cam/rockers/cam chain. I haven't checked the cam chain tensioner. Waited for my manual to show up, and they sent me a cb350 four manual, so...

I have a few projects going on right now, but I've had a blast building this bike in particular. I bought it back in October of last year, it was completely original, ran amazing, and has merely 20k miles on it. I paid the man, rode it straight back to the shop and pulled it apart. My budget...

KZ650 parts: 18" spoked rear wheel with hub and decent tire. It's a drum rear (drum not included). Hub has 5k original miles, wheel/tire unknown. But very good condition. $100 shipped Speedometer/tachometer - 20k original miles, both work, glass is perfect. Chome bezels are near perfect...