Search results

...

Re: Moto Guzzi V50 II Cafe The clearance between the pinion and crownwheel is adjusted by the shim(s) that sit on the pinion shaft behind the rearmost taper bearing. The procedure recommended in the workshop manual is to coat the pinion teeth with engineers blue, reassemble the rear drive and...

Re: Moto Guzzi V50 II Cafe Glad to see you've picked up work on the Guzzi again Dale. Last time I looked in, you'd finished the concept, tore the bike down, built the seat. It was largely due to inspiration from your thread, and the concept pics that I pulled my V50 out from below a tarp in...