Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
I know there are alot of rockers in the 503 area what with Rockers NW im just wondering if we have any folks living in good ol' vancouver. Sometimes im not trying to cross the river to ride, weve got good roads up here too!
Hi all!
Im from the good old PNW, just north of vancouver WA. Ive got two bikes currently, a cb360 thats torn down into boxes and the motors getting a good going through on the bench right now and then an 81 xs400 which is the subject of this experiment!
Ive lurked and lurked and lurked forever...
So I went cheap the other day and just put the lowest of the low octane in my xs400's tank at the gas station and I immediately regret the decision. I started losing power in spurts on my 40 mile ride home from work about ten miles out from the gas station in the form of slow or no response from...
Picked up a 1981 xs400 dirt cheap the other day to ride around while the cb360 is going through its overhaul. Running into some problems with the "plug-n-play" gauges (and pretty much anything else electrical on that bike). Can you only run a stock tach and speedo or can you actually splice...
So I have a 74 cb360 that im doing my first build on learning as I go and I have been thinking of ways to reduce weight lately. Ive always enjoyed kickstart the little I have ridden so I figured I would start looking into removing the starter.
Before I start ripping into stuff I know very...
Hey there! Just knocking out the introduction as the first post! New rider and builder from vancouver, wa though I spend most my time round the camas and portland area for any other nw locals out there.
Picked up a pretty decent cb 360 a few months back to learn how to ride and how to wrench on...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.