Search results

Wow... this is an old thread that I didnt see! ... sorry... Yes... This is a custom seat built specifically for this bike. You can tell how the seat meets up to the tank and blends itself into the tank. Bhppy101 AKA "Cafemotowerks"

1982 Kawasaki KZ1100 Spectre Finished my seat and tank.... Gotta do a lot of cleanup....motor paint...frame paint.... and add a mini speedo and signals.

Yep... if its poly against poly than it will chemically bond together as it were 1.

What kind of resin are you using? Polyester or epoxy?

Good catch!

Did or didnt? If you didnt get any sparks... that means that your main ground does not have a good connection. Follow the ground from your battery to where it connects to the frame.... Check and clean that connection at the frame.

Yep... check your ground first.... When you try to jump the solenoid... does it spark? If it shoots some sparks out and you still get no movement from the starter than thats most likely the culprit. You can pull your starter and hook it up directly to a battery to see if it spins.

Thanks. Yes... I was going to mount a mini speedo but I changed my mind and I am fabbing up a bracket to use the original gauges both speedo and tach. it will lower it quite a bit from stock to keep the look low profile

Thanks Dewski ;) Snapped a few pics today after installing the tail light and signals.

Mounted the tank and seat up and snapped a few pics.... I'll take some more ouside once I get my tail light and turn signals on

I made my seat pan....glued some High density foam and shaped it to my pan.... and wrapped it in vinyl

Comming around the bend 15 minutes from my house on Mulholland near the world famous "Rock Store" Between Agoura Hills and Malibu

Ask and you shall receive :) just snapped this pic with the KZ650 seat on my 70 cb450. If you remove the seat latch where the back oif the tank mounts....it will bring the seat down about an inch. The first pic shows the regular seat....the other pics shows where I would trim it for this bike...

just finished with 4 coats of PPG BMW Black. I'm going to unmask the tank and shoot about 4 or 5 coats of PPG clear. Hopefully it will be dry enough to pit it back on the bike late this afternoon to get a better idea on what its going to look like

forgot to mention... it also has a small lip at the front that covers the tank arch gap ;)

Heres some dimensions: 27 1/2" long 8" wide in the front 10 3/8" in the middle at the widest point 14" long in the seating area 2" tall from the bottom to the seating area... I made this taller than I am using so it can be trimmed to your needs :) 9" tall from the bottom to the top of the hump...

I havent posted any of my projects on dotheton.com in a while so I thought I should post something :) I picked up a "MINT" KZ650 with only 10,000 miles... I was going to keep it completely stock so someone could keep it as a collectable but the unfortunate happened. The gentleman that I picked...

Re: NEED HELP QUICK The Poor Boy - A Tale Of A CB550 Not too sure...

Re:NEED SOME ADVICE QUICK!!!! The Poor Boy - A Tale Of A CB550 If you happen to miss the auction...I have a GL1100 front end if you wanna buy it :) You are only about 20 minutes from me

If you dont have a title for it in hand, They may want you to do a CHP VIN inspection before you get a new title and registration