Search results

I just received my Keihin (31mm)CR special in the mail today. Does anyone have a set installed on a CB750 SOHC (bored to 836cc)?? If so, what size main jet are you using?

I found the correct needle and many other parts I forgot I had. Thanks

These guys have them. I think they will fit your application. $20 US is very good. http://www.cyclexchange.net/Honda%20Page.htm

I need one carb needle for the late (black engine)CB750 SOHC. It's a 29mm Keihin PD type carb and the needle number is F2051F. Thanks.

Thanks for the info. I thought the only major problem was the valve spring retainers. The products from dynoman are great and the service is amazing. Good luck on the rebuild. Are you going to use the 836cc or the 1000cc pistons?

I'd like to buy your old F2 engine, let me know how much you'd want for it. I'm curious to know exactly what you mean about the valve guide problem, since I'm rebuilding a few of them. Take care.

Due to the new pistons and connecting rods, my mechanic (Ultimate cycle in Hamilton) says I should dynamically balance the crank, rods, pistons and while I'm at it, the clutch basket. He said the only guy he recommends is in the Ajax area. Does anyone know of a place in the Burlington to...

Re: Valve spring shims. Thanks for the spring shim info. nothing is mentioned in the manuals about performance spring installation. Yes I'll be checking coil bind, piston to valve and valve to valve clearances. The new cam has .360 lift and 270 degrees duration. I have no idea what the stock...

Prices seem to be pretty fair. http://www.cyclexchange.net/Engine%20Parts%20Page.htm

Prices are a little high. http://www.m3racing.com/

I purchased some new KPMI high performance valve springs, they came with 0.060" shims. The CB750 heads have a steel base cup below the springs. Do the new shims go under this base cup? Also my new cam says valve lash for intake and exhaust 0.004", seems a little tight for a hot running 836cc...

Buzz the shop owner/manager is amazing for technical engine questions. He has been drag racing the CB750 from it's birth. They have a great deal on webcams, stock up....they usually cost much more. http://www.dynoman.net Ride safe...take care. Sean

http://www.facebook.com/profile.php?id=780820392

This site is a dream come true. Excellent job fellow caferacers! I have 5 motorcycles, and the two I love the most are my 77&78 CB750F2's. Both are in the process of getting major engine work. Cosmetics will be touched up over the winter and I hope to ride with your group sometime next spring...