Search results

I have a 74 CL125s, I'm a 200lb guy & while riding the bike on smooth road it feels good but seems to hit rough spots in the road hard. bumps/holes/and such it can hit pretty hard, the stock shocks are decent & seem ok but is this just the small size of the bike? Is there anything i can do or...

My questions are about using electrolysis specifically, not the general rust removal using other processes/products. I'm quite fluent in auto body repair & have experience using electrolysis for restoration. I understand how electrolysis works but have yet to experiment with its use on...

on a 1974 CL125 or similar bikes, the rear fender is attached to the frame, how? does the fender have metal studs that slip into rubber grommets or is this threaded & screwed from the other side, thru the frame, into the fender?

Do not use copper gaskets if they are to come in contact with aluminum engine parts. Copper, when near or against aluminum or zinc will cause a chemical reaction & it will deteriorate the aluminum. Do not use paint that contains copper on aluminum or zinc & vise-versa. I dont know what other...

while searching for replacement parts on honda/direct, some parts there are 2-3 options for the same part. How do i know which i need for my bike. My bike is a 74 cl125s1, When searching for parts im looking to replace rubber, gaskets, etc.. stuff that may or may not need replacing but new...

Hey guys, I have a question for you. Im going thru my bike, Looking at the parts breakdown diagrams. I'm looking to replace gaskets & parts that should be replaced because of age. My bike has only 3,300 miles on it. I have a few leaky gaskets on the bike, leaking oil just enough to be wet...

On 7/9/2012 I purchased a '74 CL125s. The bike has just over 3,000 miles on it now. Its all original, & clean, & i probably paid to much for it, but i wanted something i could use to save on gas. The bike looked great from the photos the guy sent me when buying it online, "Its Mint, Its a...