Search results

anybody have some old, STRAIGHT, valves they want to sell? or an old top end? looking for valves. Thanks! 1969 cb450 engine PM me or email

where to buy new ones?? i know its prob expensive to buy new but does mikuni make new carbs for the 450? any help and shortcuts .... and what size to use?

tons of stuff on this bike, so many to list. new top end rebuild and total carb rebuild and jet. so much going on with this bike, way fast. shoot an offer and ill answer any questions... located in southern california email is Bmoscos@gmail.com

totally rebuilt my BS34 mikuni carbs, re-jetted them for my 4 into 1 exhaust, the bike is running faster and idles like a champ. now, i was burning a small amount of oil before i started working on the bike. now, after i ran through the carbs and rebuilt them, it seems like im buring even a...

So I recently got a rebuilt kz1000 and the bike is great, but not good enough yet. I pulled off all the extra electrical crap and I'm only running headlight, tailights, stop/start high low switch. Who the heck knows of a better way to wire this! Or a pre made wiring harness??? Obviously I have...

trying to find out what size my fork tubes are so i can slap on a pair of clip on bars. anybody know what size in mm the forks are?? and.......where to find a descent pair of clip ons . something in the 100 dollar range?

im not made of money and im trying to find a descent pair that wont break and throw me off a bridge. i think i have seen a couple posts about 33mm clip ons and they are just stupid hard to find. help

trying to get a clutch for my cb350 four and i was wondering if i should just get one that fits exactly to my bike or is there a better clutch from a different model that will fit....? maybe from a 400/500/750? or should i just keep my housing and buy new plates? they run a little expensive but...

my 72 cb350 four has a knock in the engine only heard at idle (1200rpm) and im am thinking it could be something to do with the rods or rod bearings...... any ideas guys??? i know that if this is the case im going to have to pull the engine and do some major work but if there is any other chance...

i have a 72 350f. i have checked other posts about tires and all that but im wondering if i can use tubes on the bridgestone spitfire tires or the avon, dunlop d404. all input welcome. just trying to figure out what works on my laced wheels.

just wondering what other model rear wheels i can fit on my '72 350f ?? got any ideas. i want to put a wider rim or tire from maybe a later model 500 or 750. could it work? any ideas or advice will help.

i know there is a tutorial or some type of guide to tuning the carbs on my 72' CB350 four. please help, any suggestions will do. ive been trying to tinker with them from the little knowledge i have and its not working.

i need to get a rear tail light for my 350f, i would prefer a ROUND one, led or not. doesnt really matter to me as long as i can set it in to the back of my fiberglass seat. suggestions please

I need a top triple clamp for a 73' cb350 four. if you have one or can give me any suggestions, please let me know. ebay is not a big help due to the small amout of these parts floating around.