Search results

Re: 72 CL100 Mini-Cafe (Project #1) cereal boxes make great gaskets by the way

along the lines of this

Re: "77 Honda CB550Four SUPER REVERSE PORT By DWMS Racing was going to do this with my 175 to avoid cutting the frame I came to the conclusion that; theres a good chance the ram air effect will mess with your mixture at speed Crap will go all over the airfilters the exhaust ports will no...

My plan exactly, I think the whole thing should "fit" better when theres an engine plugging that gap too

oh trust me That fairing wont look anything like that at all The shed was actually tidy before i started looking for things to prop that up with ;)

i suggest firing the engine up with some fresh oil and giving it a good Italian tune up (get it nice and hot and alot of revs) im betting the valves are just a bit sticky

Wow, Far too long inbetween updates Have been flat out these last months (and it shows, i look like shit) Too many hours at work and not enough beer is what im guessing :P Have just finished rebuilding (cam chain and top end) my gn250, will give it a final clean up today and see if i can sell...

it sits down inside the oil filter housing

Have been plugging away at this, and the morrie, and the new job. So busy busy. Picked up two large halogen lights on stands for a couple of bucks, so can get some work done in the evenings now. have since built some nice free flowing headders and stripped down and engine (tipped it upside...

Story of every build i have ever done ;) Am hoping to pick up a bench top lathe and see what parts i can ruin. Did you consider an adjustable cam shaft while it was on the lathe?

Hey, im interested in hearing any tips you have about the head work. Im about to do some to one of my heads for my ca95 project

It is

Cleaned up the front suspension and finished most of the stripping on the front end (still some small flecks of paint, but no matter). Its a shame no one will see them, until i start cutting holes. dummy engine and some pipes i had lying around fitted no tank Tank Making engine sounds

Have run out of gas in my welder, so have just tacked a few bits together Cleaned up the front springs (though you wont ever see them) and a couple of other bits Once i finish off the welds and tidy a couple of bits up i will take some photos of the completed carb housings and frame mods Have...

Interesting you bring that up. I have a wee cylindrical tank left over from another project (from an ancient mower i think). I have been thinking about mounting it either inside the frame, or strapped on top. It wouldn't grant much range, but the idea of this build is to go as fast as possible...

Put in a couple of hours this afternoon. Have done some further work on the engine mounts and have made up the appropriate spacers. Also did a little more work on the carb situation, some work with a hammer and dolly and a small amount of cutting. Now the carbs fit fine (less of course the...

Have had this in boxes in my shed for a while now. The bike itself cost me $1, i later picked up 2 complete engines and alot of spares for not much more. Less the engine and indicator lenses the bike was pretty much complete. Bike is a Honda C95 (160 Dream or thereabouts) 1958-1967 Engine is...