Search results

PM sent

I'll Grab some measurements and get back to you.

Bump

Time to clean shop, I want these parts out of here. If you think my price isn't fair feel free to make an offer. I'm also terrible about checking on here, so if i don't respond my email is nbraun147@gmail.com Fiberglass seat pan - 95 shipped Fiberglass fender - 70 shipped 37 mm clip ons...

Well I might look into it if it's cheap enough. I've never raced before, so I won't be winning anything but I planned to run in the 250cc+open class and the vintage class, and just want it to be somewhat competitive when my skill catches up.

Gotcha, thanks! Without having done my research, is there a big difference between the two? Still a good option for a race bike?

Vintage Honda gurus, is this an xl350 centerport?? I know it's a terrible photo, but wasn't able to get a closer picture. I've been looking into building a bike for flat track racing and I know these are a great platform. Thanks! https://i.imgur.com/LwubhWF.jpg

Picked up a 41mm front end off of an 09 ex650. I do have the wheel with it too, just not pictured. I plan on swapping stems with this one, as the 650 stem is too large for a bearing swap.

Not sure if this is the best place to put this, but I do want to build something similar to a race bike, so it seems fitting. I Have a 78 gs750 titled frame that I had bought for it's engine. It sat around for awhile and i decided I would try and use some of the other parts I have to build...

Parts Added.

Decided i'm tired of having all these parts laying around and that it's time to get ride of them. Prices are without shipping, and my location is 57006. Feel free to make an offer on something if you don't like my price. Lastly, I may not be the best about remembering to check my PM's, so you...

Sent you a PM.

Looking for a set of PD Carbs for a 77-78 cb750. Looking for a set taken off a running bike or a set that were recently cleaned, so i can put them on and go. Thanks!

I don't know a whole lot about front ends and such. But looks like a WL springer off of a big twin harley.

They're fairly rough, they're sitting on a locked up motor, and missing one float bowl. But I figured they could be used as parts or rebuilt if someone wanted to. Not really sure how much they're worth so make an offer!

Alright, if you have the stock spacers i'd like those too.

I'm in need of a cb750 69-76 rear cush drive. A set of stock coils, and either a stock R/R setup, or one off of a later DOHC. Thanks!

Have a 79 gs750. The bike ran fine a year ago, but then was put to the side and forgotten about. Started back up on the project and decided to get it running again. Went through the carbs and replaced gaskets and cleaned jets. All the float heights are set right. Well #2 carb leaks a bunch out...

79 gs750. It has a similar setup. Should i just use some contact cleaner and scrub it?

The contacts in my headlight switch are no longer working. I can use a jumper wire between the different contacts and get it to work, but the actual switch with the contacts will not work. Any ideas on restoring the contacts to working order? Thanks.