Search results

Not sure if the pipes will fit on a CL350.

The rearsets are universal.

I don't remember, haven't seen them without heat wrap in over 3 years. They were in good shape. Make me an offer.

Recently moved out of state and had to leave the bike at my parents home. They want it gone so I'm looking to part it out. Have put a lot of time, love and a bit of money into it. It's a '74 360. Below is a pic of the final build, which I think turned out well. I just don't have the space or...

Looking for both round and a flat rubber mount that will fit a 74 CB 360. Doesn't need to be new, just want something that works. Thanks.

Thanks for taking the time to respond. Here's the flasher relay. It only has two outputs, but the bike has 3 wires. Green, grey and black. Tried all 3 in different combinations, but nothing changed. Actually, even without the flasher relay plugged in, the lights still function the exact...

Just started wiring this up. Looks like I may be in over my head. I have the tail light wired as below (2 LED strips acting as brake, running and turn signals) with a 12v flasher relay. When I hook the battery up & turn the key, the rear lights come on. The left hand controls, however, don't...

Sounds like a legit solution, kosmoto. Will give it a shot. Do have access to a welder, just don't know how to use it. Still a noob, j-rod. Not sure what I'm supposed to be seeing. Looks like a good setup for the set. Have a pic from the other side? Sucks to hear trek. Suppose I can give it...

Looking for clutch and throttle controls w/ wires and integrated levers. Something that will work with a 74 360. Bought some cheap controls and already the components are beginning to snap off.

Installing my rear sets, got excited and cut the brake arm up before double checking the spring. It's close to fitting, but not quite. The only solution I can think of is to heat the spring and try to bend it to fit. Not sure if that will compromise the strength of the spring though. Any other...

Decided to just go with some generic ones for the time being. Thanks though.

Looking for both clutch and brake (drum) control assemblies (w/ wiring attached). Let me know if you have anything.

Might not find much interest here, but I have some extras. Send a message my way if you need anything. Front turn signals + assembly Rear turn signals + assembly Mirrors Rear shocks Brake light + assmebly Battery box Tank emblems

So it's as easy as replacing the stock relay with a digital? sounds great.

New to wiring and looking to install an led strip to act as a running/brake/signal light on a '74 360. Curious if I need to pick up both a load resistor and flasher relay in order to make this work properly (or if neither are necessary).

Not in Michigan, but somewhat close (IA). Would appreciate Wangofree. It's been a while, let me know if you still have anything. Thanks.

Thanks for the suggestion on the fins. I'll give it a shot next week. Very easy to go overboard. Trying to hold back a bit on worrying about the details. Making progress. Seat is about finished. Initial fiberglass. Good position, but with foam added it wouldn't allow enough room to...

Where did you get those fork gaiters?

In need of some (4) exhaust retainers for a 74 360. Also looking for the following: Switches brake/clutch levers Headlight bucket/lens Speedo/Tach Doesn't matter if the latter are original parts (as long as they fit and are, preferably, black). Let me know if you have anything.

Judging by how successful this thread was originally, thought it was necessary to post an update. Welded the hoop on this morning Gas tank finally filled in, not looking too bad. Debating whether to have the pipes painted in flat black (powercoat) or just wrap them. This seems...