Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
I am in need of (1) intake valve for my CB360 head, PN 14711-286-030 SEE HERE: http://www.dotheton.com/forum/index.php?topic=74339.0
This the immediate need to get my bike back running, however I will also take a full set intake/exhaust if the price is right.
CB350 and CB360 are interchangeable...
So this happened... Everything was fine and I was out on a ride about 5-6 miles into it I lost all power. Previous to that I was on the highway ~65-70mph. Got about a mile down a side road and that's when I lost power. Towed it to my dad's and found out the left cylinder was not firing. OK not a...
I have a newer CBR front end that has a 35mm stem and no one is making a bearing that is 35x48.5x15 upper and 35x50x14.25 lower to mate to the CX500, or any other older Honda. So my question is, wouldn't it be possible to just fab my own bearing cups for the stock CBR bearings to be used...
Time to beat the proverbial dead horse:
I am having charging issues with my '74 CB360, there it's out now. As much as we have gone over this on the boards I have gone over it on my bike. And usually with the same end result, something will work for a little while then go back to not working...
I am installing LED flashers in '74 CB360 and purchased an electronic relay:
Maybe it's the relay I purchased but I do not get even close to 11-12 volts from the L Gray wire when all 4 flashers are hooked up and they flash incredibly slow
<img...
http://www.dotheton.com/forum/index.php?topic=16099.15
See this thread for explanation of what is going on.
However I have a question that I hope can get answered. I have some "extra" wires on the Honda harness that do not have a match when going to the new controls as follows:
Left side...
So I've run into an issue on my build, I have a 3.5" rear rim and I mounted a 130 tire on it. I am wondering if there is anything that I can do successfully to eliminate this chain rub. Obviously I know a narrower tire will solve the issue and that will be listed as my last resort. I have a...
I ordered a rim from Buchanan Spokes a while ago and figured since the stock cb360 rear rim is an 18" that I would be safe reusing the stock spokes, well it appears the spokes are a bit too long as they still have quite a few turns left to get tension and already sticking through. Is there...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.