Search results

You can just use JB weld or filler and then sand them back. No need to remove the mounting tab

What will it cost shipped to Australia, Post Code: 4217? CB350F, Stock including Horn + LED indicators. Thanks.

Did you end up figuring out what was wrong with this? .. Sorry for bringing back and old thread but figured I would ask here instead of starting a new one as I have a similar issue.

Yeah, it's a stock tank and it fits and works :/ I will just run a Y and dual inline filters before the Junction. At least if one clogs ill be alright. Thanks.

I've just done some further digging through the forum and found that maybe my petcock is not standard?

Hey guys, Just sorting the final bits and pieces of my cb350f project and wondering if you can help le with my fuel lines. The petcock has two outlets and the PO only has one line going to the carbs in the centre of the 4. Is this correct? Of so I assume that I just put a T/Y joint in there...

This is my home garage. My room mate and I race jetski's and I ride them in the Jet Stunt Extreme show at seaworld. Ill have to get some pics with my bike in it. It's usually a little less roomy than this depending on how close we are to a race and also changes colour fairly regularly as a...

Thought I'd share some photos of the tank that my buddy just finished for his cb250 project. It was a collaboration between Five Three Designs who do some of the best vinyl work in Australia and painter Tim Ryan. The tank was painted, vinyled, and then cleared. Also added in a picture of Tim's...

My one is currently cracked so on the look at for a decent new one. Has anyone used rubber from see guys ? http://www.claussstudios.com/id45.html

Thanks for your help.

I'm about to cut up my cb350f and install a brat style seat. Obviously the original seat aided in the securing of the tank. So now I'm wondering if the stock forward rubbers and the rear rubber are enough to hold the tank in place or do I have to add to my DCC seat pan in order to extend over...

Hello! Have a few buddies that have been in the cafe scene for a while and decided I'd jump on the wagon. After owning a fair few new bikes I decided it was time for a new project so coming into our summer so that I can enjoy my ride to work along the Broadwater and beach (see pic). I picked...

Gday! I chasing some side covers for a CB350F, Doesn't matter what colour as long as they are in decent condition. I would also like the badges if you have them. Also if anyone has a decent rear tank rubber mount along with a tank cap seal and tank cap pins (every store online seems to be sold...