Search results

Working on a 1984 CB700SC and found that whoever was in the carbs last didn't get the slide needle in the jet before putting the diaphragm top back on and bent the ever living shit out of the needle. No taper codes or anything on the needle just 2SK. Keihin carbs and was wondering if anyone...

Damn. ok I might just have to do that. That is clean.

Thanks for the replies! I think I am just going to solder all the piggy backing into 1-4 splice and then heat shrink it like this...

also would like to add http://www.cycleterminal.com/ http://www.corsa-technic.com/

So I have actually made a few wiring harnesses before, but I really want to clean the power wiring coming to the front up. I am trying to get rid of all the jumping from connector back to connector back to supply power to them all. I am planning on running HL, TL, blinkers, indicators, key, and...

Christopher Hayes here. Mobile, AL Work as a bartender. Ride a 1979 Honda Hawk 400 with a NightHawk 450 motor as a daily driver. Building a 1978 Hawk400 now Also will be building another Hondamatic Hawk 400 after that.

Just got my wire in!! Looks great. Sent it first day postage ran(after MLK day) and got it from Indiana to Alabama Gulf Coast two days later. Thanks again Mark. You have been invaluable in my effort to get this bitch wired right again.

So, I have a 82 Nighthawk cb450sc engine with compression in the 130's on both cylinders; it should be in the 180's. I have replaced rings before on other engines, but now I am thinking of boring out the cylinders ont his one up one(0.25). Should I even be thinking this or should I take it to a...