Search results

I'm in as well. Ive been fooling around with 3D printing for prototyping parts. Unfortunately I dont have the use of one, so I found a local guy on 3DHubs.com. I initially modeled this on TinkerCad. I wasnt going to print all of it, just to get an idea of what the program could do. The grey...

Sorry, in re-reading, my post was confusing. What I meant was the hole in the actual fork tube (directly left of the fork seal - #22 on the diagram). What im trying to ascertain is whether by changing the tubes to that of a different model (CL350 lower with CB400N tubes), am I going to run...

Thanks BarnBurner, appreciate the response. I did consider the whole front end swap, but cant find a good donor locally and I would prefer to be able to look up close first (rather than buying sight unseen). Will I have any issue with the design of the fork tube? I notice my current tubes have...

Hi all, I have a 1972 CL350K5 im rebuilding. Ive done a heap of googling trying to find the answer, but nothing concrete. Hoping DTT can help. I was tempted to do a whole front end swap, but its a bit costly at the moment. Instead I just want to clean up the front end. My current fork tubes...