Search results

Hi All, I'm currently in Hong Kong and don't have access to my CB200. Thought I'd check out some local stores here to see what filters they have available for smaller bikes (there seem to be many on the roads). Anyone know the stock carburetor outside diameter, ie. Pod Filter Internal...

As can be seen in the video and the photos it seems I'm running only one cylinder... There is a heap of unburnt muck being thrown from one of my exhaust pipes, the muck smells like fuel. I have not tuned the bike to run efficiently on the VM20s but I have done the basics like check valve...

Hope everyone had a good new year. I'm looking for advice, and hopefully photos from someone kind enough to take the time. ??? Doing the last few things on my bike before I send it off to get sandblasted. I am unsure about an issue that poses a safety risk, electric and throttle cable...

Seems to be a common theme in this forum at the moment but I'll add another kind word! Stand up guy! Highly recommended seller! Thanks again! ;D

I'm chasing the spring used to return the brake pedal to the resting position. I have the spring for the electrics, just not the spring to disengage the rear drum and return the pedal up. Can anyone help?

I've been doing some reading, seems that most of the Honda's have a speedo ratio of: 2240:60. http://www.dotheton.com/forum/index.php?topic=13883.0 My question is, do all Hondas have the same? I've got a Honda 1979 CB250N Superdream that I am giving the Cafe treatment too (amazing how much...

What are my options here? I purchased a kit from Pyramid Parts for my '74 CB200 that does not even come close to fitting my bike. Has anyone replaced their stock bearings with a tapered setup on the CB200? Do the part numbers below match to part numbers on a different bike (is there a way to...

Hello, I'm not about to race my CB200, its only to be a first bike for my girlfriend. I increased my rim size slightly on the front and rear to 1.85 in the hope that I can safely fit wider tyres, the stock size for both is 1.60. What would be the suggested tyre options? The stock sizes for the...

Hello! I've got a project thread going on here: http://www.dotheton.com/forum/index.php?topic=21150.0 My replacement DID Rims arrived today from Thailand (finally). So I thought I'd start to look into what it takes to lace the wheel, there seems to be a good article on this here, the comments...

Hello, I have started a project thread here prior to realising I should post questions under the 1800 topic (new to the forum)... http://www.dotheton.com/forum/index.php?topic=21150.0 I have put two videos below, the first shows the engine with a very vicious starter motor noise. It concerns...

First of all, a big hello to everyone one on the forum, i followed many builds on here and its been a great source of inspiration! I've been rebuilding a CB750 for over two years now and have recently purchased a "quick project bike". I believe its a '74 CB200, engine no. CB200E-1023XXX After...

I'm looking to replace the carbs on my 1974 Honda CB200, seems most here use the Mikuni VM20s on the CB175/CB200. I've read on the forums that 17.5 pilot and 135 mains should do the trick... Other than the Carbs and replacement jets what else is needed? Some sort of solution for choke and...