Search results

  1. V

    Iron & Resin Terrain 2 Bag and Waxed cotton tool roll - Both unused.

    Bought these two items a couple of years ago, but decided they are no longer needed. Both have been stored indoors and are unused. The Tool roll still has the labels attached, both come in the original packaging The Terrain pannier has multiple mounting options, including using it as a...
  2. V

    SR250 1996 swingarm install help please

    Just put the motor back in my SR250 project and I have noticed a bare section of bush showing. I cannot recall removing anything from here (it's been 4 years since I stripped it down) :-[ Please see the left hand side of the picture below, you can clearly see the bare bush. The exploded view...
  3. V

    SR250 New Piston ring help please?

    Just about to pop new rings in and checked the sizes of the old rings, they are mainly gapped at 0.65mm ish. Took the new rings out of the packet and placed them in the bore only to find they overlap 5mm!! is this correct. In my old karting/2 stroke days they rings only needed a small fettle if...
  4. V

    SR. 250 rear shock eye to eye dimension?

    Just midway through a street tracker build and need to purchase some new rear shocks. I have measured the ones on the bike and they measure 320mm e2e. When I rang hagon they said the shock for the SR. 250 is 300mm e2e. Does anybody know what the stock shock e2e length should be? Ta Dave
  5. V

    Problems with an SR250 fork disassembly - Help please

    Hi everybody, Trying to dissemble my forks and I have managed to get the top nut out, the spring is out and the oil drained (which looks like the original 20 year old stuff) :o The problem I am having is that on both legs the lower bolt just keeps spinning with the damper rod (or at least I...
  6. V

    Can't seem to remove the rocker pivots from my SR250 - Help please?

    I need to strip the head to have is aqaublasted, but I can't seem to move them. I have tried to use a 6mm bolt and pulled the pivots, but they seem pretty tight. :( Will a little heat help? or is it a case of a slide hammer fabricated with a 6mm thread to go into the pivot? any help will be...
  7. V

    Yet another SR250 Tracker UK Build

    Well I picked this little thing up for £300 with a full years MOT and 6 months tax. Untitled by eastham_david, on Flickr was a bit oily, looked like it had never been cleaned P1050488 by eastham_david, on Flickr My biggest concern was this exhaust stud was loose, looks like a heli-coil is...
Back
Top Bottom