Search results

Obtaining a legal TITLE from the state where you actually reside using the VT registration may not be possible. check your DMV first

Part Two is identifying exactly how you can (or can not) obtain an actual legal motor vehicle title from the state where you reside - once you have the VT registration in hand.

You don't want to just cover them up, the flap opens under vacuum of a running engine to allow some airflow. A solid choke slide mod would be a flood-o-matic conversion. Looks like on the three of them, you are missing the pin,. spring and choke flap. As you have one complete choke slide, you...

Welcome back Joe ! I don't remember exactly what it was you needed, but I probably still have it !

Thanks ! I should be in the running for sheeple bike of the month ! nice airhead btw :D

Pics of Sheeple IV are here : http://www.dotheton.com/forum/index.php?topic=2495.msg813415#msg813415 ( no build thread as it's the same as this one)

So here is a replica of my brat style replica from last year's replica :) so this one is "Sheeple IV" Since it's basically the same as the last 360, here is the build thread to "Sheeple II" if you are interested: http://www.dotheton.com/forum/index.php?topic=62814.45 a "before" and some...

thanks guys ! the nice compliments make me feel like I just won bike of day or something :)

XS360 Ratty Bratstyle Replica "Sheeple II" Before: AFTER:

do a leak down test , it will tell you more than a compression test on two stroke. You might have leaky crank seals ( and the black plug could be a little trans side oil being sucked in )

First, I removed rubber from the inside of the filter coupler so it would not block the atmospheric and air ports of the carb. I replaced the stock 135 main with a 145.5. I replaced the stock 17.5 pilot with a 42.5. The mixture screw is out 2 turns. I raised the needle up one notch. Also note I...

The brown and green power the field coil , the combo unit identifies low voltage limit and energizes the coil to begin alternator output. The reg then cuts field coil power to cease charging when charge is attained. make sense? It is easy to understand on my simplified diagram here...

If the screw is on the engine side of the carb, it is a mixture screw: Turning this adjusts the mixture volume from the pilot air/fuel jets . Turning it right ( IN) leans idle by reducing the mixture volume, turning it left ( out) increases the mixture volume to richen idle. If the screw is on...

thanks... guess what I found. Yep, another XS360, this one was used as a theater stage prop . The tank, covers and fenders were rattled black and the seat cover is fake, but it came with a box 'o stuff including the carbs, original bars, etc. I guess I should build another douchetastic...

I'm far less freaked out then :P

:o ouch! Although the casting process improved for the one piece head and improvements were made over the years ,such as the round port E exhaust , the actual cams and valves are the same parts on all of the TX/XS500's heads '73-'78. The the higher comp 2F1 pistons in that E motor are also a...

threw it up for $3400.. already sold http://chicago.craigslist.org/nwc/mcy/5023347818.html

Here you go: http://www.dotheton.com/forum/index.php?topic=62814.45

In the listing, I'm going to offer - " may also take partial trade on your junky piece of shit bike that doesn't run " ;)

thanks ! time to drag home another project !