Search results

Hello, I'm looking to get a micrometer for measuring crank journals, cams, etc. I know the bearing tolerances are around 0.002-0.003 ", so I'm assuming I need a micrometer with resolution of 0.001 mm to really get the job done. I don't want to say the words cheap/affordable along with decent...

So I found some parts I dont need including an unused motion pro speedo/tach cable. I have a picture with the info below, and I bought it for a 69 cb350. Never used, in the plastic and with the rubber condom thingy. The total length (from tip to tip) is a respectable 27 inches. I also have...

Something else spotted parking on a college campus in south Georgia..Maybe ebay is to blame?

Got this gem on a craigslist deal. Mix-matched body parts, things missing, about 24k miles. First on the list of course is a good old carb cleaning. Little bit of pine sol and elbow grease got those going, and first start up revealed a tick from a tappet (video) and a cracked oil pan. At...

Just finished my carbs and cranked this bike for the first time in a few years. Idles great and revs etc, but there is a tick that seems to be coming from the left side valve train (cylinder 1 likely). This is my first bike with hydraulic tappets so valve adjustment is kind of out of the...

Hello, New to the forum and thought i would post my little project. I picked up this old bike from someone who pulled it out of a barn in South Carolina. She was crispy, but had just over 3000 original miles, good compression, and obliterated diaphragms. I also picked up a 1971 cl which had...