Search results

Here are a few of my inspirations for the wheel/tire look im going for, just to give you all an idea. Notice the tire/wheel size is the same front and rear.

The Suzuki GT500 has a 2.15x18 rear wheel, now for the front?

Would it be possible to lace rims from another bike onto my hubs that would fit a 4.00x18 front and rear?

Just for referance. http://www.irc-tire.com/mce/

so why is it a 90/90/18 f, and 110/90/18 r fit no problem?

I have a 77 GS-400, front wheel is a 1.60x18, rear is 1.85x18. The tires are currently Avon's 90/90/18 f, and 110/90/18 r. I like the fatter tire look and I'm looking at the IRC GS-11. Can I fit a 3.5x18 on the front, and 4.00x18 tire on the rear? The chart on IRC's website call for a...

I would still like to know if there is another option out there besides cutting the spring. Did any models from that era come with a shorter, but similar shock?

JRK, I considered cutting the spring also, but my concern with clipping the spring is with the stock shock/spring being so soft it may bottom out. That’s why I was opting for a stiffer aftermarket. However, if what Maritime says is true and the stock shock doesn’t fully compress anyway, I...

Silver, Any idea what that site might be? I've been searching and can't find any 11".

Already ahead of you Big ;) , I picked up a CM400 tree to swap in. It should allow me to slide the forks up a bit. I just need to figure out the rear. Ideally I'd like to do this as cheap as possilbe, however I'll check out Dimecity, thanks for the tip.

Hello ladies and fellas, new member here! :) I'm looking to lower the rear of my 78 Honda Hawk, unfortunately its a clevis to clevis (13" bolt to bolt). I'm hoping to use my stock top clevis mount on a shorter shock to lower the bike, say maybe a 12" or 11" shock. Would anyone know if this...