Search results

Finally got started back on the CB175 today and I don't know if this frame is bent or if it just sits crooked. I put the empty cases back in the frame and they bolted up with no problem.

Hey, I got a 175 cases split, down to the frame. Have most of the parts. I know I don't have spokes, speedo, tach, or lights. It pretty much just needs to be cleaned up and put back together or would be a good parts bike. I'd like to trade for a small 2 stroke project something less than 100cc...

I'm getting ready to powder my hubs on my 175. Would it be better to replace the bearings before or after I get them powdered. I know you have use heat to get the bearings in and didn't know if that would mess up the powder?

Are these a good set of oversize pistons or should I just look for some NOS Honda ones?

Found these at my buds place. He had the complete volume. There are really interesting.

Whatcha think?

99 Somoma for an 84 rabbit gti. Would you do it?

Ok so I got my timing and point gaps set and the plate is... well here's a picture so the left point contacts the points cover and grounds it out causing it to misfire. It runs great with the cover off. So what are my options here? The only thing I can think of is grinding the cover till I can...

Ok so imma change my oil tomorrow and the last couple times I just put regular plain ole Honda 4 stroke oil. I know synthetic oil is a step up but what's ya'lls preference???

This made me laugh!!!

Finally made it to the beach!!! Also I took this pic on the way and think it looks cool. :-)

http://atlanta.craigslist.org/sat/mcy/2484958872.html

http://www.treatland.tv/treats-gang-headlight-p/treats-gang-headlight.htm Look at the price!!!

So I picked this up a few weeks ago for 40 bucks. Just got some forks off eBay cause the old ones were stuck and bent. I need to get the head cover and clutch basket to get it goin for now but I'm also looking for the CL pipes if I can find some on the low.

It's today!!! So go skate!!!

So my friend just got pulled over by the GA State Patrol on his MB5 for no tag, insurance, or license; however he and I were both under the impression that because the bike is less than 50cc that it dud not require these. Anybody know somebody who knows somebody that could help him out?

So i just rejected my carbs and they are still a little rich even at the top end but the correct jets should be here tomorrow I hope. Any way the reason I'm posting is because when I stopped I found this!!! It's leaking through the two bolts directly above the points cover and also by the...

So I just finished disassembling my engine and I was wondering if anyone knows something good to soak then in to get all the crud off them. I've already spent 2 hrs cleaning them with soap and water but didn't get too far.

Does anyone have a link. I can't find one anywhere that I don't have to pay for!