Search results

Third time is the charm! Again I cleaned out the tank new fuel lines and charged the battery and started her up. 5 years later and it started up pretty easy. It seemed like the right cylinder was going in and out and i couldn’t get it to idle right, but i was really really happy to know it still...

Just read your whole build so far. Great job! I have had mine for around 6 years now and this is round 3 getting it started again hahah. Damn I hope this time I finish it. Following along!

Sent from my iPhone using Tapatalk

Yeah. It's pretty cool stuff. I did a gloss black under so it would look traditional, but if you did red or any other color it shows through and would look cool I'm sure. Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

The clear looks great. Sent from my iPhone using Tapatalk

Got the seat back from the carbon dip. I like it flat, but I'm going to clear it because the tank is glossy. Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

looks great. Thanks You make it seem so easy to do, although in reality i'm sure it wasn't.

Ive been following your build! it kinda got me off my ass and back to work so thanks! love your seat. :P luckily the dip is free through a friend, but i think i might try carbon next go around. im sure it is hard to get it to look how i would want it though. I have my fair share of kinks too. I...

Everything is coming together. I'm getting the seat dipped in carbon fiber so that will be 2 weeks out. I'm also waiting for new brake pads and a speedo cable. I still need to get the brake switch to turn on when I use my back break. And the rear sets in general need adjusting. I haven't been...

Im painting the seat and that should be it. it was a weird way to do things, and i will do things differently on the next, but i learned a lot and it works haha ::)

Sent from my iPhone using Tapatalk

anyone have a picture of what they use to hold the bottom bolt from spinning on the forks??? i'm going to take them apart again and see if I can get it to stop leaking once and for all. I apparently just got lucky and the one tightened correctly, but cant seem to get the other side to stop...

Re: '74 CB 360 Cafe Build - Boomerang bike looks great. I want your exhaust. :D

I have done a little bit in a whole lot of time... :-\ So my front forks are still leaking. I used an impact to tighten them and also replaced the crush washer. Any other ideas? its a very minimal leak, but still very annoying.

were at about 4300 in salt lake

yeah. I just got a cx500 and now things are going slower on both of them.

No unfortunately its still not finished. :-\

did you get that bottom bolt tight with the impact? i have the same problem as of forever ago. Just havnt got around to fixing it yet.