Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
Can't believe someone read this post and commented on it again. But, since you did, let me tell you that I learned a lot from my experience and ultimately getting into the motor helped me to correct some underlying issues that ultimately would have shortened the life of this bike. One of the...
Everyone calm down. Everything will be alright.
-- The lapping was done lightly, just to remove minor pitting. I researched this quite a bit before doing it. It is fine to do this on these valves.
-- I did use a straight edge and feeler gauges to check the head.
-- Yes, I used a scotchbrite pad...
Inching towards getting this thing back together. Still waiting on parts, so trying to stay busy.
Got the valves cleaned up as best as I could. 30 years of baked on carbon and grime sure is tedious to clean. Also lapped the valves.
I also got a good straight edge and checked the head. It is...
Successfully installed the Time-Sert today with the help of my wife as an extra set of hands.
I was pretty concerned about getting the hole drilled nice and square/true. Because of this, I searched around for different types of drill guides and ended up getting one of the Gator units off...
No way to fix that except for tearing down the motor, so out it came again from the frame. And she is now all in pieces again. Will repair the threads with a Time-Sert.
Plan is to do a few things while it is apart:
-- new piston rings, and hone the cylinders
-- mill the head to make sure it is...
So, if you've been following along, you know I've been chasing down the cause of an oil leak. Ultimately discovered the suspect head stud was pulling the threads from the engine case, hence why it wouldn't torque properly. See attached pic of the threads still attached to the stud when I pulled...
Won a front wheel off eBay. It is from an early 80's GL1100. It is 18" x 2.5" to replace the stock 19" x 2.15". Should give me better tire choices, reduce rolling weight a tad, and handle better.
ben
Got my superbike bars and mounted them up. I really like the position and how it transforms the bike.
Disregard the missing mirror. I ordered the wrong ones, and waiting for a replacement that isn't reverse threaded on the right side.
ben
Pulled the valve cover last night to test my theory on the oil leak. The left rear head stud had two copper washers on it, one stock, the other thinner and smaller diameter. It also had some gasket sealer on it. If you recall, I once found this one finger loose, and couldn't confidently get it...
Newly developed oil leak as seen in attached pic. I think it is from that one head stud nut that was loose. Looks like the thread lock didn't hold or the copper washer isn't sealing. Picked up a new/used cap nut from the local salvage yard along with a washer from a poor engine left out in the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.