Recent content by Booligan

Tridon EP34. It has three prongs, one for each wire and one that you run to a new ground point. Easy install and works fantastically well with the LEDs I installed. $6 from Autozone.

I don't have a kick starter installed on mine.

It's not even that, it's more along the lines of "if I want a fast vehicle, I've got a bike for that" lol. Much cheaper and easier to do!

I had a Miata prepped for drift events for a few years. I alternated the build between drift and road racing, but ended up doing a lot more drift events. Those were the street wheels, I had 13s with a variety of tires for track use. Greddy based turbo kit, Hard Dog bar, Corbeau seats, Tein...

"very well made not a hack job" I mean, he did put carpet down over the plywood, that's top notch stuff.

Parked next to it's bigger sibling, my 79 CB750.

Parked with its little sister, my CB175 cafe.

Better pics now: And of course, gotta have one of my fat ass on board. 6'1" and 225 lbs makes most bikes look tiny:

So nice and clean. I really need to get this thing out and get a proper photo shoot done with my photographer buddy.

I'll grab a pic next time I yank the seat off. BTW, got her running nicely after yanking her out of storage. It was running on only one cylinder, and it turns out the carb was gunked up on the non-running side preventing it from getting any fuel from the tank. Cleaned it up and it fired right...

She's still coming along. Nothing new cosmetically, just working on getting it running a little bit better. The left cylinder is hit or miss as far as running consistently, I think the carb is being a little wonky. Right cylinder is running great. I'm also fabbing up some drop in exhaust plugs...

They're the 2.5" versions on DCC. BTW, got the bike out of the shed and fired back up for spring time riding. Need to do an oil change and valve adjustment before I go on any rides, but she's still looking and running mighty fine.

I'm planning on going with a satin silver paint finish.

That's way rad. SCCA Rallycross is an absolute blast.

Well, I finally got my spacers finished and my Roc City Racers Bonneville seat mounted up. I need to do a little bit of shaping at the bottom of the seat to better match the seat, as well as adding a bit of rubber stripping at the front to close the gap between the tank and the seat, all while...