Recent content by jorn.s

Was one of the first issues with mine. Had to tune the spokes. Wheel was oval. Some spokes was extremly tight, and others was totally loose.

I bought this one. Replaced the clock that shows the lights and stuff. Looks stock on the bike. http://m.ebay.com/itm/12V-Silver-Tachometer-Gauge-0-13000-RPM-for-Car-Auto-Motorcycle-White-Face-/301712280843?nav=SEARCH

Troms Sent fra min D5803 via Tapatalk

Nei, desverre. Men ligger videoer på youtube. Ganske enkelt. https://www.youtube.com/watch?v=_2xRnGlqzeA Sent fra min D5803 via Tapatalk

Just make sure the marks for the camb shaft is correct. And hand crank the engine to check if the valves hit the piston before you start the engine. Sent fra min D5803 via Tapatalk

No, its not a original ace engine (cg) with push rods. Its a zonghshen cb engine with overhead camshaft. Thinking about getting the 4 valve convention kit for it. But the top speed is quite ok now, so time will tell what i will do with it. Sent fra min D5803 via Tapatalk

Got a 50cc with a ohc 125cc. Had to build new mounting brackets in front of the engine. And cut down the link arm for the gear. Sent fra min D5803 via Tapatalk

Buy the boat from me. I make 35-40 feet fishing boats for a living. Just delivered the worlds first eletric fishing boat. For only ~1.5 million $, and yes its thousands of hours with carbon/glass fibre work on every boat we make :) Sent fra min D5803 via Tapatalk

Noticed the spokes on mine did have different tention. Some were really really tight. And others were loose. If you hit them, they should make the same ish sound. I suspect its the really really tight ones that breaks. Sent fra min D5803 via Tapatalk

Yes same cdi. Mine was still a 50 with a big bore kit when i installed the cdi.

The cdi made no differene on my bike. Except the engine was a little more easy to start.

The 14/43 sprockets was about perfect for my set up with the 70 cc big bore. Could not rev it out on flat ground (but almost), and was pulling fairly nice up steep hills. A 22mm carb might help a little on the top revs. The inlet maifoild is only 19mm, so that was why i bought a 19mm carb for...

replaced everything. the stock 50cc exaust is tiny. It was no way it could be used on the 125 engine. Used a dremel on the 50cc exaust to remove some welds on the inside of the manifoild pipe. The welds are huge, so take a look when you get yours. And did some dremling on the exaust port on...

From Norway. Bought 2 ace 50 as project bikes. One for me and one for my friend, so when i ordered 2, we got the big bore kits for free. And shipping was not that bad. Have done some mods. Handlebar mirror, tacometer, new brake light, new battery (original was crap), new rear tire (original was...