Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
I have a 76 cb400f and have been getting some seat time again, notice on the last ride after the bike is good and warm it can be difficult to find neutral. I actually stalled it and could not slip in to neutral, after a bit of messing around I was able to get it to free roll (but no neutral...
thanks neevo just had a good cb400f diagram enlarged, haven't fixed it yet but i think i am getting closer. was trying to figure out where the voltage entered the circuit. after studying the diagram I believe its from the brown/ blue wire I found unplugged in the headlight bucket. will jump some...
ok have tested across the fuse and it is good, there is no brown/ blue tracer in the headlight bucket but did find a solid brown wire with nothing hooked up to it and it did have continuity with the brown/blue coming out of the fuse box. I found one joint with four black wires in the headlight...
was using my old analog meter, just picked up a new innova digital unit it has several omh settings and an auto setting. will study it and continue testing
I am not getting power to dash lights, but do have continuity from switch to tac light bulbs, checked bulbs they are good. will try the other tests later tonight. what I cant understand is the ignition switch is early in the system, its getting power on the black wire terminal (headlight) on run...
ok did all tests you had mentioned and have continuity in all, i am still thinking when I turn ignition switch to the run position with battery hooked up test light should show power on the brown and brown/white terminals, could a short later in the circuit some how affect this? THANKS m
yeah fuse is good , at the ignition switch I only have power to the black wire when switched to the on position. not to brown or brown/white. if I put jumper between black and brown I have tail light. same results with new aftermarket switch. frustrating!!!
have been doing some continuity tests on my my ignition switch (cb400f) not getting any power to the brown wire, or the brown/white wire. with the switch in the on position I have continuity between the red wire terminal and the black wire terminal. but no continuity between red and brown...
can somebody tell me where I can find single and double bullet connectors and shields , as used inside headlight bucket, there for a 76 cb400f. thanks mike
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.