Search results

  1. Rywilly

    2001 ZRX1200 Part Out

    Hey All, I've got a 2001 ZRX1200 I am considering parting out. Bottom end side cover was welded on, instead of someone fixing it right. Considering parting out. Muzzy exhaust is a 7 out of 10. Tank has a slight dent on top 6/10 Seat has some tiny little tears in it 6/10 Front Forks and...
  2. Rywilly

    Considering reviving 2001 ZRX1200R, might need a new bottom end

    Hey all, Just picked up a ZRX1200R, it's definitely seen better days and some idiot welded an engine side cover on after they snapped some bolts instead of backing out the bolts the right way. It's leaking oil out of that same area. Tank and exhaust are in good condition. Looking for someone...
  3. Rywilly

    aftermarket ignition switch not working

    I'll have to add photos. It did start right up before, I think the switch is meant to be rated for 25 amps? Not sure this one is. Any ideas on that? Looking for one which will fit my new custom set up - just not sure which ones out there would work. Is the 25 amps the significant info?
  4. Rywilly

    aftermarket ignition switch not working

    Got the wires un-crossed as far as I can tell, but now bikes not turning over - its a four wire ignition switch but aftermarket.
  5. Rywilly

    aftermarket ignition switch not working

    If the turn signals wires are swapped that'll do that?
  6. Rywilly

    aftermarket ignition switch not working

    Hey all, I got a lower profile igintion switch to improve the look of my 78 GS550, it was supposed to plug in no problems, as far as I know. Plugged it in to the existing plug on the harness and my gauge turns on, but nothing else, and it seems its backward. When the key is in the off position...
  7. Rywilly

    78 GS550 Seat, tail/light, rear fender, turn signals, mirrors FS/FT for Carbs

    Sorry, seat is gone. I’ll hold on to the back end for sure. I haven’t done the 650 swap. I’m not quite savvy enough for that. I’m back to the original carbs, someone just moded them trying to smooth out the throttle for some reason, so I had to remove the little extra pump and plug the holes. It...
  8. Rywilly

    78 GS550 Seat, tail/light, rear fender, turn signals, mirrors FS/FT for Carbs

    BUMP, still for sale. Carbs are gone though.
  9. Rywilly

    Anyone build speedo mounts? Need a solo/center mount for 78 GS550

    Looking for a single mount/center mount bracket for a 78 gs550 cafe project. I have clip ons, so I am trying to mount it to the original triple tree mount for speedo/tach. Anyone make them or know where I can find one. The tach is 61mm. Not sure what the measurements of the original speedo/tach...
  10. Rywilly

    77-79 KZ650 Carbs for sale (Best Offer)

    Not sure what condition they are in, haven't had them apart. I was not given any information on them, but after some research, I am 99% sure they are 77-79 KZ650 Carbs. Make me an offer.
  11. Rywilly

    What are these Carbs From?

    I am wanting to put them on a 78 GS550 with pods and a 4 to 1 Kerker.
  12. Rywilly

    What are these Carbs From?

    I should say that the current carbs have been jetted for the pods and pipe that are currently on the bike.
  13. Rywilly

    What are these Carbs From?

    After chatting with some guys over on the KZrider forum - I am pretty sure they are the 77-79 KZ650B carbs. I have heard multiple sources that they will bolt up to the same boots etc as the original carbs? As far as jetting - would the same jets work you think? I am guessing I will need to...
  14. Rywilly

    What are these Carbs From?

    After some searching on KZrider I think they must be vm24ss carbs.
  15. Rywilly

    What are these Carbs From?

    Not sure if that is worth noting, but thats all I am finding.
  16. Rywilly

    What are these Carbs From?

    No numbers, the only other marking is "MIC" on each Carb on the opposite side of the Mikuni markings.
  17. Rywilly

    What are these Carbs From?

    Any guesses what bike these are from? They are mikuni's, I acquired them in a deal, but the guy didn't know what they are from. He restored old Kawasaki's mostly, so that is my only lead. A picture of the other side: https://flic.kr/p/GBFbD1 Thanks again!
  18. Rywilly

    79 XS850 Tank

    Make me an offer
Back
Top Bottom