Search results

Kick start keeps getting caught at the bottom of the stroke and sits there until you pull it upwards. Engine doesn't start? Not sure whats wrong

Not yet no, Kickstarter also has huge kickback Sent from my iPhone using Tapatalk

I just put a 2 into one exhaust and pod filter on it also, could it be due to running lean? Sent from my iPhone using Tapatalk

Re checked all timing, can get the bike to start now but it blows heaps of white smoke and shortly dies out Sent from my iPhone using Tapatalk

I put new fuel through the system, it kicked off and lasted for a few seconds before it died out. Tried re kick starting and it backfired out the pod filter. Sent from my iPhone using Tapatalk

If I remove the spark plug and kick it over then refit the spark plug it kicks through fine for several strokes then starts clogging up again Sent from my iPhone using Tapatalk

Yes the spark plug is fine its not hitting the piston, its the same one stated in the repair manual.

I removed the spark plug and it kicks over fine? Sent from my iPhone using Tapatalk

I have installed a new piston and camshaft to my 1981 Honda CB250rs and now I'm having trouble kickstarting the engine. THe kickstarter lever makes it way down but sometimes gets stopped and wont swing all the way through. I have checked the timing and it all seems to be in place. Anyone have...

Will a battery eliminator work with the ultimate wiring harness (link below)? If not what's the smallest battery on the market? 1981 Cb250rs Honda (kickstart only) http://www.ultimaproducts.com/18-530.pdf Sent from my iPhone using Tapatalk

Tried kicking her over this afternoon, think the carb needs a rebuild first. All wiring is just about done Sent from my iPhone using Tapatalk

I want to use this type of wiring harness: (http://www.ebay.com.au/itm/161915209190?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT) Its a custom Honda 1981 cb250rs and I need something simple to help with the wiring. Although im unsure as to where the CDI and charging cables from...

Brake light bracket needed next, and to get rid of the speedo for a much smaller gps speedo unit. Sent from my iPhone using Tapatalk

Im not sure if any of you are going to be able to answer this question, but does anyone know where I could get a swing arm bolt to fit my cb250rs? Are there any other bikes that would fit? Finding it hard to find a genuine part here in adelaide.

I'm hoping someone can point me in the right direction. I need to have a custom swing arm spindle rod made. Where in Australia (based in Adelaide could I get someone to custom build me one to a certain size? Sent from my iPhone using Tapatalk

new photos

Been way too long since I've made a post or even much progress with uni starting and a new job. But here she is so far. Just got her back from having a custom 2 into one exhaust being built. Things left to do: Complete wiring Have the seat upholstered Order new throttle and choke cables Tune...

What's the specs on the Yamaha on the right? Looks killer Sent from my iPhone using Tapatalk

You absolute legend, that worked ! Thank you heaps Sent from my iPhone using Tapatalk