Search results

Hey All, I've got a 2001 ZRX1200 I am considering parting out. Bottom end side cover was welded on, instead of someone fixing it right. Considering parting out. Muzzy exhaust is a 7 out of 10. Tank has a slight dent on top 6/10 Seat has some tiny little tears in it 6/10 Front Forks and...

Hey all, Just picked up a ZRX1200R, it's definitely seen better days and some idiot welded an engine side cover on after they snapped some bolts instead of backing out the bolts the right way. It's leaking oil out of that same area. Tank and exhaust are in good condition. Looking for someone...

I'll have to add photos. It did start right up before, I think the switch is meant to be rated for 25 amps? Not sure this one is. Any ideas on that? Looking for one which will fit my new custom set up - just not sure which ones out there would work. Is the 25 amps the significant info?

Got the wires un-crossed as far as I can tell, but now bikes not turning over - its a four wire ignition switch but aftermarket.

If the turn signals wires are swapped that'll do that?

Hey all, I got a lower profile igintion switch to improve the look of my 78 GS550, it was supposed to plug in no problems, as far as I know. Plugged it in to the existing plug on the harness and my gauge turns on, but nothing else, and it seems its backward. When the key is in the off position...

Sorry, seat is gone. I’ll hold on to the back end for sure. I haven’t done the 650 swap. I’m not quite savvy enough for that. I’m back to the original carbs, someone just moded them trying to smooth out the throttle for some reason, so I had to remove the little extra pump and plug the holes. It...

BUMP, still for sale. Carbs are gone though.

Looking for a single mount/center mount bracket for a 78 gs550 cafe project. I have clip ons, so I am trying to mount it to the original triple tree mount for speedo/tach. Anyone make them or know where I can find one. The tach is 61mm. Not sure what the measurements of the original speedo/tach...

Not sure what condition they are in, haven't had them apart. I was not given any information on them, but after some research, I am 99% sure they are 77-79 KZ650 Carbs. Make me an offer.

bumb

I am wanting to put them on a 78 GS550 with pods and a 4 to 1 Kerker.

I should say that the current carbs have been jetted for the pods and pipe that are currently on the bike.

After chatting with some guys over on the KZrider forum - I am pretty sure they are the 77-79 KZ650B carbs. I have heard multiple sources that they will bolt up to the same boots etc as the original carbs? As far as jetting - would the same jets work you think? I am guessing I will need to...

After some searching on KZrider I think they must be vm24ss carbs.

Not sure if that is worth noting, but thats all I am finding.

No numbers, the only other marking is "MIC" on each Carb on the opposite side of the Mikuni markings.

Any guesses what bike these are from? They are mikuni's, I acquired them in a deal, but the guy didn't know what they are from. He restored old Kawasaki's mostly, so that is my only lead. A picture of the other side: https://flic.kr/p/GBFbD1 Thanks again!

Make me an offer

Make me an offer