Search results

hey guys I have a 1981 cm400t that currently has the spoke rims with drum brakes. I am looking to switch out the rims for the black comstar ones. to do this I need to buy the front brake caliper but I am looking to stay with cable brakes not hydraulic does anyone know of any that would fit? thanks!

hey guys I have a 1981 cm400t that currently has the spoke rims with drum brakes. I am looking to switch out the rims for the black comstar ones. to do this I need to buy the front brake caliper but I am looking to stay with cable brakes not hydraulic does anyone know of any that would fit? thanks!

Selling my motogadget m button. Bought it while rewiring my bike but ended up not using it. Brand new. Asking $40 plus shipping. Thanks! Sent from my iPhone using DO THE TON

Yupp that was the mistake I red the wiring diagram wrong the oil and neutral switch wires were harnessed together so I thought it was all one unit but now I see one is the oil and the other is neutral. Thank you for the help! :) Sent from my iPhone using DO THE TON

Oh I thought that was the oil pressure sensor? Sent from my iPhone using DO THE TON

Is that it? Sent from my iPhone using DO THE TON

Hello guys I am wiring up my cm400t but for the life of me I can't figure out where the neutral switch is. I looked thru my manual and can't find it. Can anyone help me thanks! Sent from my iPhone using DO THE TON

Any particular reason you avoid soldering just a pain to do? Sent from my iPhone using DO THE TON

I'm rewiring my whole bike and installing a motogadget m-unit blue. I guess the best way that I've found so far from researching is to just solder all the wires into 1 wire and ground it. Sent from my iPhone using DO THE TON

hello I was wondering if anyone has any good tips on how to bring all my ground wires for my bike together and ground them with one single wire instead of having multiple grounds on my frame. I am using an M-unit blue so they will be grounded to that. thanks!

It has a 7a fuse in it now. If I get like a 10a fuse will that help with the extra voltage from the running lights? Sent from my iPhone using DO THE TON

Hey guys I am having problems with my headlight fuse. I spliced in some bar end turn signal running lights into the headlight and now the fuse keeps blowing. It not knowledgeable about wiring so any tips to prevent this is much appreciated thanks! Sent from my iPhone using DO THE TON

That seems to have worked! Thank you! Sent from my iPhone using DO THE TON

Ok I will do that see if it works thanks!! Sent from my iPhone using DO THE TON

Hey guys I'm looking for some tips or advise about my morimoto bar end signals. I got them all hooked up I spliced all the wires into the proper wires for the rear turn signal and headlight wire for the running white light. When the bike is on the running lights work great! However when I turn...

hey guys I got great news put the cap nuts and crush washers on all the studs and they are no longer leaking! bad news is that now there is a leak coming from the back of the head gasket :( im thinking maybe I should go back in the instructed order and tighten the bolts down again bc I...

Ok great I will keep that in mind thanks for the tip! Sent from my iPhone using DO THE TON

Hey guys another question. I will be getting the crush washers this Monday in the mail. Should I put those on with just the cap nuts or should I put a stainless washer on top of the crush washer? Sent from my iPhone using DO THE TON

Also I don't have a torque wrench that shows lbs of pressure is there any way to do it without one or do I need to buy one bc idk what 16 lbs ft Feels like. Sent from my iPhone using DO THE TON

Ok great thanks for the help guys! Ordered the cap nuts and some more crush washers to try this again I will update in a few days if the problem was solved. Sent from my iPhone using DO THE TON