Search results

This bikeis looking great. I am building one into a street tracker and I am planning on the same treatment on the front wheel. Maybe I missed it if so sorry. What spokes did you use on the 18" with the stock front hub? Eric

PVA-Polyvinyl alcohol Right?

looking good keep it up. That tank looks to be off a 1975 XL250/350 same tank I believe.

The green looks good. Great job. What paint did you use?

Thanks for the replies I will try the toothpick idea and if that dosent work I will try the others and see what happens.

SO time flies. What have I accomplished. Primed the tank, dissassembled the free spinning motor to find out the clutch and oil slinger had parts missing, the cylender looks good enough to hone. I need to find a piston after I have it measured. As you can see the cylender had quite a bit of...

does anybody have an idea about painting the letters on this switch after I paint it black. I have tried a touch up pen from the auto parts store and it made a mess. Thank you Eric

So how is the rebuild coming along?

I am considering the same thing was it a simple drop in swap? I have heard that it was. Eric

Nice and simple. How about a link to the plans.

Bike looks great the white headlight goes well.

I thought it would look good when you were done and you are proving it . Good looking bike.

If you know the rear rim is the one you want for the front what is the possibility of getting another rear wheel to take the rim from it is already drilled with the 40 holes? Eric

Check servicehonda.com or bikebandit they should have a breakdown of your bike and the parts to fix the petcock. O-ring 2.71 and gasket kit 14.06 Eric

Glad I could help Eric

Where to start on a project? Well teardown then ......... Well I have started to detab the frame and prep for powder. Has anyone used a XL350 swingarm on a 250 its one inch longer giving a longer wheel base. This may be a long journey from the grave. Oldnbroken yours is an insperation. I...

I picked this up in July cheap with a title but a frozen motor, stripped spark plug hole junk tires and a lot of rust. The plan is a trackerish build but I don't think it will be a pure build so its here in the spacials. Eric

DCC has some striper (ie White/Black) in quite a few colors. I think if you wan't original colors it will take several orders to different suppliers. You could find out who makes the wire and then contacrt them directly.

Re: CB200 '73 tracker project You have made a wonderful little bike with some out of the normal thinking I really like the fenders.

Re: 1974 XL350 - Bob & Chop build - LET THE FUN BEGIN... The Tear Down started Question, where did you get the exhaust pipe parts for your pipe? also check out oldrice.com they have an XL board with some good info on these bikes. I believe a good carb swap for this bike is a 34mm Mikuni. It is...