Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
Like the title states I am having 2 specific issues.
I finally got my carb sync and turned my adapters, I was going through the manual in the adjustment section describing how to sync and balance.
Issue 1
I have got the carbs synced very very close according to the gauges, but when I go the...
I have been hanging around a while, and I wanted to get a build thread put up to show my progress thus far on my current project. DTT is a cool site with a shit load of really cool people (kinda rare these days on forums), so I wanted to put my stuff out there to get some feedback and maybe help...
as title states, just the right carb. What could be causing this? I have searched and already tested the folowing and found them to be good
Reset float height as per manual (2 times)
Ensured floats actually float (no holes)
I have soldered the overflow tubing inside the bowl becuase they were...
I am just looking for some opinions, I figured this would have been covered a million times but I didnt see any in my search.
Anyway, what type of oil are you guys running in your bikes? I am most interested in the twins (thats what I own) but all info is good info.
http://www.kawasakimotorcycle.org/forum/vintage-motorcyle-info/92592-carburetor-diaphragm-repair-works.html
Thought this was an interesting read, I am going to give it a shot since I found a few pin holes in one of my diaphragms on my re-build. (I do not want to go for new if I can avoid it)...
So I am in the process of rebuilding my carbs, I have come across an variance between the two and I am not sure which is correct
circled in yellow are the ports on the bottom of the carbs, one is closed off and one is open....I assume they both need to be close but I
am looking for someone to...
I am looking for a universal or aftermarket set up for my push/pull throttle cables. I am currently using a universal throttle sleeve with cut down cables but I am looking for a more permenant solution. I have no electronics mounted to the clip ons and I would like to keep that clean look (so...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.