Search results

Check for smooth operation of ALL choke butterfly's. if one hangs up even slightly on those wire clamp bands, it's going to start badly. ...I know.

Nice to hear you have it running! Regarding the fuel leak, I had this happen to me. Check a couple of things. If your gasket was the round one, it's likely to have came out of the groove when it was installed. Check for a pinch. If you ever have to take a bowl off, it can be a real bitch to...

Pablo. I'm positive I have the bracket you need. PM me if you need one.

Looks nice! ...and quite familiar. :)

Caf'd Out, drop me an email at bradley.stevenson@att.net. Your profile at DTT will not accept PM's.

PM's are not working to this member. I can find the profile just fine. When I reply to the PM sent to me, I receive the message in RED Unable to find member 'caf'd out'. There's something wrong with the DTT site. If i search the member profile and pull up the member, select send PM, type the...

I'm unable to respond to your PM's. DTT keeps telling me 'Unable to find member 'caf'd out' when I select reply. Post your email and I will respond directly. -Brad

Looks like a nice stocker rising from the grave! Love these 400's. Great platform to work with.

Re: First build-CB350F- Project Rapier Thanks fatherjon. I don't want to hijack corsair's thread. I'll keep watching for updates!

Re: First build-CB350F- Project Rapier Good luck my friend! Let us know if you get stuck. I've built up two of these I love em so much. Here's a pic of my 350 frame with a 400 heart transplant:

Sorry if you've seen these before. Moving this to a better location on the forum. Below are pics of my CB400.. Well, actually it's titled as a CB350F, but has a CB400F at heart. Much work has gone into this machine. A couple of years ago, I built a CB350F cafe for my wife. Along the way...

The hand controls aren't too tough. It just takes time. I sat down with an Ohm meter and traced down what wires went to each switch and integrated with the factory harness crimping on connectors from Vintage Connections. I also installed a clutch switch and used the starter button cut out to...

All, My brother came down and took some great shots of my finished project. Check em out below! Addl pics at: http://s1231.photobucket.com/albums/ee520/indyrider2/?albumview=slideshow

I've lived the life of a purist, but since found more fun collecting others scraps and building what I want. Below is my project just getting close to completion...1972 CB350F rolling frame bought title-less (now titled), CB400F engine bought for $37 carb-less on eBay (yes, folks that price is...

http://www.cnn.com/video/#/video/us/2011/07/12/ok.heat.buckles.highway.kotv?

Indianapolis Rockers Reunion Show http://www.rockersreunionindy.com/

Indianapolis Rockers Reunion Show http://www.rockersreunionindy.com/

Indianapolis Rockers Reunion Show http://www.rockersreunionindy.com/

Re: Deacon's 1972 CB350 Cafe Project - Fender Mold Done By chance would you be willing to make another? I'm in need!

No bolts? Dude you're asking for it. Clamp those fork tubes down, or we'll be reading about you in the paper!