Search results

Seat loops; Bent several the other day 1" OD x 14 ga(.083) 12" legs, seemed like that's what everyone wanted 7 1/8" - 7 1/4" outside to outside, realize 1" is pretty easy to spread and you can go a ways before it makes the bend look goofy My bender die is a fixed radius...

For Sale: parts to convert GT 380/550 to dual disk. GT 750 master cylinder needs rebuilt, lines/junction block and whatnot, I'd go braided but whatever left side caliper mount-the calipers are the same side to side it's the mount that's different, 3, or most of 3, calipers I should...

$20 + freight continental US only 1" od x 14ga(.083) wall erw 9 3/8" tall, 7 1/4" wide Can throw in a little chunk o' tubing if you need to split it to make wider. Split in center of the bend and take some out if you need it narrower.

1975 GT 550, I've had it 5(?) years, put 4500 miles on it in the last two. It's been super reliable for me. Well-patina'd, rough in a good way New tires mid-season last year Michelin A50 Macadams. Think the battery was new last spring. Braided stainless line, drilled rotor. Have a...

The Legend of the Cafe Racer

If this is covered in VonYinzer's sticky I apologize, my 'puter got the herpes the other day now I can't open pdf files. Although I perused the information a few times pre-herpes and don't remember it being covered. Thanks to VonYinzer for a bitchin' sticky. So: Guys that have built a...

.