Search results

A little lube goes a long way

dead sexy

Nice scoot!! too bad about the tank... Hey the tank and the tail light are almost lined up... why not integrate the two?

Im thinking that the chemicals are wicking out of the holes.

I like the change up on the rear frame triangle, flows much better!

One thing... at least on my 850, the boots were left and right..... having them mismatched wont line up with the carb bank... let us know how you make out.. And a side note, I didnt push my carbs all the way and had an air leak that I was chasing with tuning....

Also harbor freight has a sandblast gun for about 20 bones... Sent from my iPhone using Tapatalk

any more at that price? put up the link... also, i'd stay away from silicone. especially if it has a slight oder of vinegar, its very acidic and will do more harm to the metal connections than good. Nothing beats shrink tube... cheaply found at harbor freight... or cover in electrical tape and...

Yep, your on track with cleaning the carbs, and never trusting the PO.. 1. adjust valves 2. clean carbs 3. inspect carb to head boots, replace if nec. 4. carb boots above have orings, replace.... 5. synch carbs 6. beer..... Good info here, http://members.dslextreme.com/users/bikecliff/ And...

+1 toss the front end and i'd ride the chit out of it!

Nice work! Now do one with sexy brass brazed joints!! And polish it! Sent from my iPhone using Tapatalk

If boots arnt pliable they need replacing, fyi. Sent from my iPhone using Tapatalk

Bench synch gets u close. Vacuum synch must be done, it helps in all ranges not just idle. A few things scare me about your cleaning process. Carbs must be torn down completely. Use carb dip instead of pinesol, blow out with compressed air after. Replace all orings inside the carbs. Usually the...

I have done this. I doubt tho its your problem. Dip carbs blow out with carb clean. While these are soaking, have you checked your valve clearances? Compression, fuel, and spark... Holy trinity my friend.. Sent from my iPhone using Tapatalk

Plug the brass port on the #3 carb, this port on #3 is a vacuum port for the vac operated petcock. Third carb from left if your sitting on the bike. On 2 &3 they are just vents. Air screw should be 1.5 turns out from lightly seated. Fuel screw ( under carb) should be no more than 5/8 turned out...

its a deathtrap! quit while your ahead! i'll come take it off your hands because i'm a good friend like that... ;) Nice work man!!!!

that works!! nice price too!

http://shop.advanceautoparts.com/p/tridon-novita-tech.-inc-electronic-turn-signal-flasher-ep34/5081327-P?searchTerm=flasher# this is the flasher I use.. no need for resistors.

Get one that is specified for led trailer lights, under 13 bucks Sent from my iPhone using Tapatalk

Re: Bucky's '74 CB360 Hardtail Bobber Build~"Root Beer float" Nice job! Ignore the circus bear riding a tricycle jokes.. Theyre just jealous. Sent from my iPhone using Tapatalk