Brethren, a question. Figuring out how to wire up and connect the indicators (that do double duty as brake lights) and taillight into the new, non-oem wiring harness. I chopped off the 5 pin connector on the harness so now have 5 wires - 1 for each indicator, one for the brake light, one for the running light and one ground. No drama. Each indicator has three wires - one for the indicator, one for the brake light and one ground. Still no drama. And the taillight also has three wires - one for the brake light, one for the running light and one for the ground. All good.
My idea is to make use of the bullet connectors I have lying around to connect all this shit together, but in order to do that the ground wire and brake light wire will each need three terminals. Is it ok if I cut 2 small lengths off each of them, solder them together to make a kind of trident and then attach bullet connectors to each end?