Rattlecan
Been Around the Block
Hey Boys,
I'm gettin ready to re-assemble my motor and instead of painting my cylinders I was thinkin about andodizing them.
Simple reason being that i've got a 2-stroker and they rely heavily on the cooling fins to keep the temps in check, and just figured that to get a really nice finish with paint it might hold in too much heat.
Have any of you done any anodizing??? I have seen a few posts on here in regards to zinc plating but I have never attempted anyting like this but i figure with a bit of direction I cant be that hard.
Do any of you know where I could buy a kit to do it?? or how to build one???
Any help would be much appreciated.
I'm gettin ready to re-assemble my motor and instead of painting my cylinders I was thinkin about andodizing them.
Simple reason being that i've got a 2-stroker and they rely heavily on the cooling fins to keep the temps in check, and just figured that to get a really nice finish with paint it might hold in too much heat.
Have any of you done any anodizing??? I have seen a few posts on here in regards to zinc plating but I have never attempted anyting like this but i figure with a bit of direction I cant be that hard.
Do any of you know where I could buy a kit to do it?? or how to build one???
Any help would be much appreciated.