CB350F stock front wheel, or just rim?

[carnivorous chicken]

My Spring project came together -- CB350F that had been sitting for years. Did just about everything short of rebuilding the engine -- it had 130psi across all for before I even fired it up -- and today I got my new tires mounted. Went to the local Harley shop because those guys are way, way cooler than the jerk who owns the Japanese bike spot (and they're cheaper for some stuff). Got my wheels back, but had to go back to get my rear wheel switched (he mounted it backward). Get the rear on, and as I am going to put the front on I notice... that big dent in the rim. I rode around the block on the old tires and felt a wobble, chalked it up to old tires sitting in the same spot for years. Nope. Bent rim. Looking for either a whole wheel set up (don't need brake rotor or speedo drive) or maybe just the rim. Needs to be in nice shape, no rust, let me know what you have and what you want for it. Thanks.

 

[ApexSpeed]

I have a stock CB350F hoop that came off of a rear setup (needed the hub/brake). You can have it for the cost of UPS shipping if you want it. It's fairly clean, too. I'd need to find a box to ship it in, though.


I'll shoot a photo after the 2nd period of the Blackhawks game is over if you are interested.






doug

 

[carnivorous chicken]

Thanks, appreciate it, but I believe the rear is wider than the front...

 

[ApexSpeed]

Thanks, appreciate it, but I believe the rear is wider than the front...

No problem.

 

[crazypj]

It's an 'upgrade' to fit WM2 (1.85") rear rim on front hub, I've done dozens over the years
Get a WM3 (2.15") for rear.
The improvement in handling is dramatic 8)

 

[carnivorous chicken]

Bike's gonna be mostly stock and on budget, I've already got everything I need, tires, etc., just want a new rim...

 

[crazypj]

Stock tyere will fit fine

 

[carnivorous chicken]

Stock tyere will fit fine

Again, appreciate it, thanks, but I do not want to do more than relace a front rim or replace the whole wheel.

 

[BCBarker]

I'm pretty sure I have a front rim from a 350F already cut from the hub. Can't remember the condition, But I think it's nice. Maybe a little pitting?

I'm out of town until next Wednesday, so PM me then and I'll check for ya.

 

[crazypj]

I have several WM1 front rims for CB360 that are exactly the same as CB350F (I have a 350 F here as well but the rims were really rusty and painted silver when I got it)
At least one 360 rim is just about brand new
Until it was mentioned I never even considered them except as something to 'upgrade' CB125/160 ;D