cb360 camshaft and rockers needed!

[crazyface]

In good usable condition. Also any other parts you may have I may be interested thanks.

 

[McADad]

would you be interested in an entire 74 CB360 engine with carbs, and do you by chance live in Michigan?

 

[crazyface]

I'm interested. But I live in California. What's the condition of the motor?

 

[Finnigan]

Hey I'm in San Diego I might have you covered on this one

 

[Finnigan]

got a came and rockers and springs

not in the best condition ever but i'd still use them

I'll post pics when i get home

 

[McADad]

The condition is unknown, other than it has 6000 orginial miles, turns over, has great compression and has had both engine recall performed. I accuired it from the original owner. It's been sitting for over 20 years. i think the cost of shipping to Cal would be alot. Located in SE Michigan.

 

[crazyface]

Yea shipping would probably be alot. Sucks. How much did you want for it anyways?

 

[crazyface]

got a came and rockers and springs

not in the best condition ever but i'd still use them

I'll post pics when i get home

Cool. Yea I'd like some pigs

 

[crazyface]

*pics*

 

[Finnigan]

Sorry I didn't get around to it last night, I'll post them when I get home

The whole engine is pretty tempting though... if you pass I might be interested

 

[crazyface]

It's cool. Yeah I'm tryin to figure the shipping costs right now

 

[Finnigan]

You can see visible wear but all surfaces are pretty smooth if you run a fingernail over them. I just noticed the chip in the cam... You'll have to get someone's opinion other than mine to see if its alright to use safely

 

[crazypj]

Not sure the locating pin will stay in place on cam?
Could probably glue it in place with JB Weld
If chip goes into area where seal runs it will leak oil like crazy though (looks like it doesn't go that far though)

 

[crazyface]

Aye, yeah that sucks. I don't think I would run that unless it could get professionaly repaired somehow.

 

[Finnigan]

Can't say I blame ya, let me know if you need the rockers. Everything I have thats engine related for the 360 is just lying around

 

[crazypj]

It could be welded and re-drilled, need someone who does cast iron with nickel rods though
Rockers can be hardwelded and re-ground (use rods for excavator bucket tooth repair, nickel/chrome)

 

[McADad]

I'll be posting it this weekend with Pics, goin to ask $250, includes carbs.

 

[crazypj]

I'd buy it if you were not so far away.
Not driving to Florida anytime? ;D

 

[crazyface]

It could be welded and re-drilled, need someone who does cast iron with nickel rods though
Rockers can be hardwelded and re-ground (use rods for excavator bucket tooth repair, nickel/chrome)

Yeah, there's not to many people who do.

 

[crazyface]

I'll be posting it this weekend with Pics, goin to ask $250, includes carbs.

Alright cool, shipping might be worth it