Dreadnotred Hellride chopper

Front caliper sorted with a Tokico that came off an EX650. The 750f fork mounts were within an inch from the caliper mounts, so it just required a small bracket to move the bottom hole, while still using the top hole. Then two spacers were machined to match the offset.




Sent from my iPhone using DO THE TON
 

Attachments

  • IMG_2790.JPG
    IMG_2790.JPG
    1.7 MB · Views: 296
I had a blast with the wire wheel digging through all the bondo on a smoothed out 70s chopper frame in all the usual spots, only to find no numbers. Looks like we’ll do it by the engine number...




Sent from my iPhone using DO THE TON
 

Attachments

  • IMG_2845.JPG
    IMG_2845.JPG
    2.1 MB · Views: 275
  • IMG_2848.JPG
    IMG_2848.JPG
    2.1 MB · Views: 266
  • IMG_2846.JPG
    IMG_2846.JPG
    2.2 MB · Views: 268
  • IMG_2847.JPG
    IMG_2847.JPG
    2 MB · Views: 271
I changed my mind and decided to run a dimpled tank. Anything in front of the down tubes runs the likelihood of interfering with carbs/air filters.


Sent from my iPhone using DO THE TON
 

Attachments

  • IMG_2853.JPG
    IMG_2853.JPG
    1.8 MB · Views: 260
  • IMG_2854.JPG
    IMG_2854.JPG
    212.8 KB · Views: 261
pidjones said:
Except that I've never seen a "matching numbers" Honda.

If I recall my CB360 engine and frame #s match. Currently stored in my neighbors garage so I can't look at the moment.
 
trek97 said:
Currently stored in my neighbors garage so I can't look at the moment.

I wish I had a neighbor that let me store stuff in his garage.
 
Back
Top Bottom