Gear change arm to fit CB750 SOHC

[rohalloran]

I am looking to find a gear change arm that will fit the gear change shaft on a SOHC K7. I have fitted custom rear sets. The part I am looking for is similar to this: (the piece with the splines)

https://www.ebay.ie/itm/Honda-CBR60...073821?hash=item2ad967a15d:g:FLMAAOSwPeRdzVqw

Do all hondas have the same amount of splines /the same diameter? The splines on this look to be a quite fine.

Any help is appreciated.

 

[teazer]

Not sure but I'd go for it. Suzuki are typically a coarser spline and most old Hondas and Yamahas are the same fine spline. I used the splined part of a CB160 shaft to repair a TZ350 shift shaft and have mixed and matched a few odd combos in the past.

You could also cut and grind a stock shift lever to work as the short linkage and get a couple of heim joints. That's not hard to do.

 

[cxman]

this one is ugly but you can find a prettier one cl350 has them

https://www.ebay.com/itm/1971-Honda...:huwAAOSwu25dj6lt:sc:USPSPriority!27295!US!-1

 

[rohalloran]

Thanks all. I'm in Ireland and there are no an on eBay Ireland or the UK for a CL350. Any other thoughts?