Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
I've been having issues with the bike randomly not turning over when hitting the start button. I remember a couple months ago I saw a spark come off of the engine when I hit the start button. It still started.
Today I was starting the bike and turned on the right petcock while I had my thumb pressed on the start button. It felt like I was touching an electric dog collar.
Bad ground somewhere I take it? That may explain why it only starts sometimes with the electric start.
sounds like a bad earth, there should be a cable from the motor to the wiring harness connected to the earth on the battery.
it could have broken off or got crimped or it could be dirty with oil etc.
cool, if the PO has ripped the cable off and its earthing though the frame and tank it could start a fire or burn out thinner earth cables as it tries to find the easiest path back to the battery.
I would run a earth cable from the battery to one of the engine casing bolts if there isnt one on the bike.
i dont know tthe bike but looking at the way its protected from touching the casing and going inside i would say no thats not it. it should go from the engine casing to the frame and another strap from the negative on the batt to the frame, or even better direct between the two
heres a shot of my earth strap on the sprocket cover
sorry photos up the wrong way
.
Well, since you saw a spark on the engine, you might want to start there first and remove, sand/clean the wires in the area where you saw the spark.
.
Where was the spark? Does it hit you when you have the clutch pulled in or part way in? DID you remove the ground jumper wire under the Top fork clamp that goes from the fork riser bolt to the clamp itself? Honda twin handle bars are rubber mounted and so are isolated from the rest of the bike, they have their own ground cable. IF that is missing the only other thing that grounds the bars is the clutch cable which doesn't do a very good job at times.
looks like it mounts to the upper rear horn bracket bolt on the left side of the frame . . this will be on the outside of the ignition switch . . there ids a hole in the switch bracket for the tab to insert into . . the tab goes forward and the relay points up.
that schematic is awesome.. going to try that. Do you think that could cause my issue? The ground wire is going to my battery and a thine green wire is also on the negative terminal.
.
that should be a turn signal relay so it should have no affect on anything and in fact, it is probably not what was sparking . . the spark is a bad ground and is probably the cause of the starter not working . . just connect 12 volts directly to the starter for a second and see if it turns over.
well, I mounted that relay. I also cleaned and tightened every wire/connection that touches the frame. The thing fired right up. I held on to the petcock while starting and there is no more current going through it.
Before that I bridged the starter relay and the started worked perfect.
I've been on this forum on and off for a while but never really needed help. Thanks to all that posted.
well, I mounted that relay. I also cleaned and tightened every wire/connection that touches the frame. The thing fired right up. I held on to the petcock while starting and there is no more current going through it.
Before that I bridged the starter relay and the started worked perfect.
I've been on this forum on and off for a while but never really needed help. Thanks to all that posted.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.