eoep
Been Around the Block
Need help with wiring. I have a sprackmoto harness.
Black -Any black wire will have voltage when the main ignition/toggle switch is set to on. This is the same color used in the stock harness.
Red –The thin red wire running through the main trunk of the harness is to activate the starter solenoid. The thicker red wire running through the secondary trunk carries power from the battery to the ignition switch.
Green –These wires should all be grounded. They will eventually link up with the negative terminal of the battery, either directly or via the frame.
Gray –The gray wire carries voltage from the signal relay to the right-hand control assembly for distribution to the left and right turn signals
Yellow –The yellow wire is used to provide power to the brake light.
Pink –The pink wire is acts as the switched ground wire for the horn.
Purple –Oil pressure wire.
Blue –To be used for the right hand turn signal.
Orange –This wire is for the left hand turn signals.
White –This wire carries power from the kill switch to the ignition coils.
my control switch is
Black = Voltage
Red/Yellow = Starter cable
Dark Blue = High beam
White = Low beam
Black/White = Kill switch
Yellow/White = ?
Yellow = ?
Brown/White = ?
Black -Any black wire will have voltage when the main ignition/toggle switch is set to on. This is the same color used in the stock harness.
Red –The thin red wire running through the main trunk of the harness is to activate the starter solenoid. The thicker red wire running through the secondary trunk carries power from the battery to the ignition switch.
Green –These wires should all be grounded. They will eventually link up with the negative terminal of the battery, either directly or via the frame.
Gray –The gray wire carries voltage from the signal relay to the right-hand control assembly for distribution to the left and right turn signals
Yellow –The yellow wire is used to provide power to the brake light.
Pink –The pink wire is acts as the switched ground wire for the horn.
Purple –Oil pressure wire.
Blue –To be used for the right hand turn signal.
Orange –This wire is for the left hand turn signals.
White –This wire carries power from the kill switch to the ignition coils.
my control switch is
Black = Voltage
Red/Yellow = Starter cable
Dark Blue = High beam
White = Low beam
Black/White = Kill switch
Yellow/White = ?
Yellow = ?
Brown/White = ?