Parting out CB360 or sell complete.

[Luck]

I have an entire CB360 that has had a lot of work done and never finished the bike. I would sell the whole thing for 300 (you pick up) or part it out. The bike has a powder coated rear rim, stainless spokes and a tire that has never been driven on. The front disc has been cross drilled, front shocks have been rebuilt front brake has been cleaned and new seals added. Motor has been gone through. etc. Parts will end up costing more than the whole bike because of shipping rates but if you have any questions, let me know. Thanks, G

 

[Jimbonaut]

Mate if you're near Montreal then I'll take it for $300!

 

[Luck]

Im in Minnesota if thats close enough. lol

 

[Jimbonaut]

Hmmm, sadly not

 

[DBerkshire]

Im in Minnesota if thats close enough. lol

Not in the market for a second CB (I wish I was) but I'll shoot the information to a few friends. Where in MN are you located? I'm just South of the cities.

 

[Luck]

On the west side of the cities. You guys can come and look at it if you want. Let me know if you want my number.

 

[DBerkshire]

On the west side of the cities. You guys can come and look at it if you want. Let me know if you want my number.

My buddy is interested in learning more if you’d like to send me a way to contact you.

 

[Luck]

Message sent.

 

[Mark850]

Do you still have the bike/parts available? I'd be interested in the gas tank if you have one in decent shape. I'm located in Eden Prairie.

Sent from my SM-G920V using Tapatalk

 

[Matnetik]

I would be interested in the following:
Drilled front rotor
Angled Clip-Ons (Do you know what the angle is?)
Are the engine covers polished? If so I may be interested in those as well

Thanks

 

[DBerkshire]

Do you still have the bike/parts available? I'd be interested in the gas tank if you have one in decent shape. I'm located in Eden Prairie.

Sent from my SM-G920V using Tapatalk

I actually ended up buying this bike at the beginning of May when I found out there were issues with the frame of my original donor. The tank has been cleaned for the most part on the interior but the gas cap has actually been removed and the hole covered. The previous owner wanted to use a more updated style I believe and possibly in another location. I'm not attached to the tank so, if you are interested, let me know.

I would be interested in the following:
Drilled front rotor
Angled Clip-Ons (Do you know what the angle is?)
Are the engine covers polished? If so I may be interested in those as well

Thanks

I'll be keeping these parts for my current build.

 

[Matnetik]

I actually ended up buying this bike at the beginning of May when I found out there were issues with the frame of my original donor. The tank has been cleaned for the most part on the interior but the gas cap has actually been removed and the hole covered. The previous owner wanted to use a more updated style I believe and possibly in another location. I'm not attached to the tank so, if you are interested, let me know.



I'll be keeping these parts for my current build.

Thanks for the reply!