chickenStripCharlie
Coast to Coast
Oh boy .... so I read somewhere that sealing the edge of your clear coat with JB weld was a good idea, in case it chips around the gas cap and what not.
So that's what I did. Sloshing the tank around to prevent flash rust as it's not 100% full I turned it upside down and didnt think much of it. Well, turns out some gas got right up on top there and totally dissolved the JBWeld and the clear!!!
And I thought jbweld was gas resistant! Wtf?!?!
Anyways ... it should be ok because it doesnt seem to have spread much and I cleaned it with alcohol and it wont be visible under the cap anyways.
Any of you guys seal the "edge" of clearcoat at the tank opening?
So that's what I did. Sloshing the tank around to prevent flash rust as it's not 100% full I turned it upside down and didnt think much of it. Well, turns out some gas got right up on top there and totally dissolved the JBWeld and the clear!!!
And I thought jbweld was gas resistant! Wtf?!?!
Anyways ... it should be ok because it doesnt seem to have spread much and I cleaned it with alcohol and it wont be visible under the cap anyways.
Any of you guys seal the "edge" of clearcoat at the tank opening?