Hobes
Active Member
https://vimeo.com/110531899
ok guru's, this is what is happening, what in your opinion would cause this.
lets start, full clean and rebuild of carbs, 2 sizes over mains, 1 size over pilot, needle raised 1 notch, pilot screws set at 2.5 turns out.
throttle cable lubes and return checked, so no hang up there. all and any advice accepted.
Pods are to be changed with K&N type, drag pipes have 8 inch inserts.
the other side of the coin is, when if finally comes back down, it will drop even further then stop. Then it's even harder to start.
so i am at a loss.
Hobes
ok guru's, this is what is happening, what in your opinion would cause this.
lets start, full clean and rebuild of carbs, 2 sizes over mains, 1 size over pilot, needle raised 1 notch, pilot screws set at 2.5 turns out.
throttle cable lubes and return checked, so no hang up there. all and any advice accepted.
Pods are to be changed with K&N type, drag pipes have 8 inch inserts.
the other side of the coin is, when if finally comes back down, it will drop even further then stop. Then it's even harder to start.
so i am at a loss.
Hobes